Philips ICE PREMIUM HP6503 User manual

ICE PREMIUM
HP6503
4203.000.3671.1.indd 1 25-10-2006 12:12:11

2
4203.000.3671.1.indd 2 25-10-2006 12:12:12

3
1
4203.000.3671.1.indd 3 25-10-2006 12:12:14

4
4203.000.3671.1.indd 4 25-10-2006 12:12:14

HP6503
ENGLISH 6
 19
 34
 47
 61
 74
 87
 103
4203.000.3671.1.indd 5 25-10-2006 12:12:14

6
Introduction
With your new Satinelle ICE PREMIUM you can remove unwanted hairs
quickly, easily and effectively.The combination of the ceramic epilating
system with the contour-following skin cooler and the new
sonic massaging system constitutes a revolution in epilation.Thanks to the
natural numbing effect of ice and massaging, the new Satinelle ICE
PREMIUM makes epilation more comfortable and less painful than ever.
The result is a silky-smooth skin and a hair growth reduction of up to
50%, assuming you use the appliance regularly (every 4 weeks).
The Satinelle ICE PREMIUM is suitable for all body parts and comes with
a skin cooler that has been specially developed for epilating sensitive
areas (underarms, bikini line).These areas can be particularly sensitive to
pain, which this special skin cooler helps to diminish.
The rapidly rotating epilating discs catch even the shortest hairs (down to
0.5 millimetre!) and pull them out by the roots.As a result, your skin stays
smooth for up to four weeks and regrowth is soft and downy.
General description (Fig. 1)
AInsulating sleeve for skin cooler
BLeg skin cooler with pivoting cooling head
CSkin cooler for underarms and bikini line
DShaving head
EProtective cap of shaving head
FMassaging element
GEpilating head
HAppliance
ICharging light
JAdapter
KCleaning brush
LExfoliating body puff
MStand
Important
Read this user manual carefully before you use the appliance and save it
for future reference.
ENGLISH
4203.000.3671.1.indd 6 25-10-2006 12:12:14

Check if the voltage indicated on the adapter corresponds to the
local mains voltage before you connect the appliance.
Only use the appliance in combination with the adapter supplied.
Do not use the appliance if the adapter or the appliance itself is
damaged.
If the adapter is damaged, always have it replaced with one of the
original type in order to avoid a hazard.
The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug, as this causes a hazardous situation.
Keep the appliance and the adapter dry.
Keep the appliance out of the reach of children.
Do not expose the appliance to temperatures lower than 5°C or
higher than 35°C.
To prevent damage and injuries, keep the running appliance away
from your scalp hair, eyebrows, eyelashes, clothes, threads, cords,
brushes etc.
This appliance contains two NiMh rechargeable batteries that may
harm the environment if not disposed of properly.
Do not use the appliance on irritated skin or skin with varicose
veins, rashes, spots, moles (with hairs) or wounds without consulting
your doctor rst. People with a reduced immune response or people
who suffer from diabetes mellitus, Raynaud’s disease or
immunodeciency should contact their doctor rst.
Noise level: Lc = 75.8dB [A]

This Philips appliance complies with all standards regarding
electromagnetic elds (EMF). If handled properly and according to
the instructions in this user manual, the appliance is safe to use based on
scientic evidence available today.
Charging
You can run the appliance directly from the mains or you can use it
without the cord when the batteries have been charged.
Charge the batteries at least 16 hours before you use the appliance for a
cordless operating time of up to 20 minutes.
,
,
,
,
,
,
,
,
,
,
,
,
ENGLISH 7
4203.000.3671.1.indd 7 25-10-2006 12:12:15

Do not charge the appliance for more than 24 hours.
1 Make sure the appliance is switched off while charging.
2 Insert the appliance plug into the bottom of the appliance and put
the adapter in the wall socket.
The charging light goes on and stays on to indicate that the appliance
is charging.
The charging light does not go out or change colour when the
appliance is fully charged.
3 For more convenient charging, you can put the appliance in
the stand (‘click’) (Fig. 2).
Optimising the lifetime of the batteries
After you have charged the appliance for the rst time, do not
recharge it between epilating or shaving sessions. Continue to use it
and only recharge it when the battery is (almost) empty.
Discharge the batteries completely twice a year by letting the motor
run until it stops.
Do not keep the appliance plugged into a wall socket all the time.
If the appliance has not been used for a long time, it must be
recharged for 16 hours.
Preparing for use
Freezing the skin cooler
1 Put the skin cooler WITHOUT the insulating sleeve in the freezer
or freezing compartment (***) at least 4 hours before you start to
epilate. When the uid has turned completely blue, the skin cooler
is ready for use.
Make sure the outside of the skin cooler is completely dry before you
freeze it.
Tip: You can store the skin cooler in the freezer permanently.
,
-
-
-
-
ENGLISH8
4203.000.3671.1.indd 8 25-10-2006 12:12:15


General information about epilation
Epilation is easier just after a bath or shower. Make sure your skin is
completely dry when you start to epilate.
When you use the appliance for the rst time, we advise you to try
it out on an area with only light hair growth.This helps you get
accustomed to the epilation process.
For optimal epilating results, the hairs should not be longer than 10
millimetres (Fig. 3)
To epilate longer hairs: (Fig. 3)
shorten the hairs to a maximum length of 10mm with a trimmer. In
this case, you can start to epilate right away.
shave the hairs completely. In this case you can start to epilate after a
few days (the hairs must be at least 0.5mm long).
Your skin may become a little red and irritated the rst few times
you use the epilator.This phenomenon is absolutely normal
and quickly disappears.As you use the appliance more often, your
skin gets used to epilation, skin irritation decreases and
regrowth becomes thinner and softer. If the irritation has not
disappeared within three days, we advise you to consult a doctor.
We advise you to epilate before you go to bed at night, as this allows
any skin irritation that may develop to diminish overnight.
Corded use
Do not run the appliance from the mains when the battery is fully
charged.
1 To run the appliance from the mains, switch off the appliance and
connect it to the mains.Wait a few seconds before you switch on
the appliance.
Epilating with the leg skin cooler
Make sure your skin is clean, entirely dry and free from grease. Do not
use any cream before you start to epilate.
1 Slide the insulating sleeve onto the skin cooler. (Fig. 4)
,
,
,
,
-
-
,
,
ENGLISH 9
4203.000.3671.1.indd 9 25-10-2006 12:12:15

The insulating sleeve prevents an unpleasant sensation of coldness in your
hand while you use the appliance. It also keeps the skin cooler cold as
long as possible.
Sometimes the pivoting cooling head freezes onto the skin cooler and
does not move when you take the skin cooler from the freezer.The
pivoting cooling head starts to pivot again after you have passed it over
your leg a few times.
2 Snap the appliance onto the skin cooler (Fig. 5).
3 Insert the appliance plug into the bottom of the appliance and put
the adapter in the wall socket.
4 Select the desired speed to switch on the appliance (Fig. 6).
Select speed I for areas with little hair growth and for areas where bones
are located directly beneath the skin, such as knees and ankles.
Select speed II for larger areas with stronger hair growth.
5 Stretch your skin with your free hand to make the hairs stand
upright.
6 Place the appliance perpendicularly onto the skin with the epilating
head pointing forward. Move the appliance against the direction of
hair growth at a moderate speed. (Fig. 7)
Make sure both the epilating discs and the skin cooler are in proper
contact with the skin.
Press the appliance lightly onto the skin.
If you are not completely satised with the epilation result, try
moving the epilator more slowly over your skin.
7 Use the tab on the bottom end of the appliance to remove the
appliance from the skin cooler (Fig. 8).
Epilating with the skin cooler for underarms and bikini line
The special skin cooler for the underarms and the bikini line reduces the
number of active epilating discs. Combined with the large cooling surface,
this skin cooler makes epilating sensitive areas less painful.You get the best
results when the hairs are not too long (max. 1cm).
1 Slide the insulating sleeve onto the skin cooler. (Fig. 9)
,
ENGLISH10
4203.000.3671.1.indd 10 25-10-2006 12:12:15