Philips Satinelle super sensitive HP6447/00 User manual

Satinelle super sensitive
HP6447/00, HP6444/00, 6443/00

2

3
2 3 4 5
678 9
10 11 12 13
14 15 16 17
18 19 20 21

4
KK
1

ENGLISH 6
DEUTSCH 12
FRANÇAIS 19
NEDERLANDS 26
NORSK 33
SVENSKA 39
SUOMI 45
DANSK 51
HP6447, HP6444, HP6443
5

6ENGLISH
Introduction
◗With your new Satinelle super sensitive you can remove
unwanted hairs quickly and effectively in an extra-gentle way.
◗The new double-active pain softener relaxes your skin like a
massage, thereby more effectively masking the sensation of
epilation.As a result, you will hardly feel any pain.
◗The rapidly rotating epilating discs catch even the shortest hairs
(even as short as half a millimetre!) and quickly remove them by
the root.As a result, your skin stays smooth for up to four weeks
and regrowth is soft and downy.
Important
◗Check if the mains voltage indicated on the adapter corresponds
to your local mains voltage before you connect the appliance.
◗Make sure the appliance does not come into contact with water.
◗To prevent damage and injuries, keep the running appliance away
from your hair, eyebrows, eyelashes, clothes, threads, cords,
brushes etc.
◗Keep the appliance out of the reach of children.
◗Only use the appliance in combination with the adapter supplied.
◗If the adapter of this appliance is damaged, it may only be
replaced with an adapter plug of the original type.Turn to your
Philips dealer or the Philips organisation in your country for
replacement.
◗Do not expose the appliance to temperatures lower than 5°C or
higher than 35°C.
◗Do not use the epilating head on irritated skin or skin with
varicose veins, rashes, spots, moles (with hairs) or wounds
without consulting your doctor first. People with a reduced
immune response, e.g. during pregnancy, or people who suffer
from diabetes mellitus, haemophilia or immunodeficiency should
also consult their doctor first.
◗Your skin may become a little red and irritated the first few
times you use the epilator.This phenomenon will soon disappear
as your skin becomes used to epilation and the hairs become

ENGLISH
thinner and softer. If the irritation does not disappear within
three days, we advise you to consult a doctor.
◗Regular massages with a loofah or exfoliating head may help to
prevent from ingrowing hairs. Do not use the loofah or
exfoliating head immediately before or after epilation.
◗Only epilate the armpits and bikini line with the precision cap (B)
attached.
General information about epilation
◗Epilating with the Satinelle super sensitive will leave your skin
smooth and hair-free for weeks.As epilation may cause skin
irritation or ingrown hairs in some women, we advise you to
read the text below.
◗When you use the appliance for the first time, we advise you to
try it out on an area with only light hair growth to get
accustomed to the epilation process.
◗(Type HP6444 only) This appliance has been extensively tested
on the armpits and the bikini line. Some women will develop skin
irritation when they epilate these areas for the first time.We
therefore advise you to try out the appliance on a small patch of
skin first.
◗After use you can apply a mild cream or body milk to soothe
your skin and reduce skin irritation.
◗Epilation is easier just after taking a shower or a bath.Your skin
must be completely dry, however.
◗We advise you to epilate before going to bed at night.Any skin
irritation that may occur will diminish overnight.
General description (Fig. 1)
AProtective cover
BPrecision cap (HP 6444) for epilating armpits and bikini line
CPain softener (HP 6444) for epilating armpits and bikini line
DEpilating head with epilating discs
EPain softener for epilation of the legs
FOn/off switch with speed selector
7

ENGLISH8
0 = off
I = normal speed
II = high speed
GInlet socket for appliance plug
HAppliance plug
ICord
JAdapter
KBrush
LExfoliating head
Using the appliance
◗Make sure your skin is clean, entirely dry and free from grease.
Do not use any cream before you start epilating.
1Put the adapter (J) in the wall socket.
2Insert the appliance plug (H) into the inlet socket (G) (Fig. 2).
3Remove the protective cover (A) (Fig. 3).
4Switch the appliance on by sliding the on/off switch (F) to the
desired speed setting:
◗Select speed I (Fig. 4) for areas with little hair growth and for
areas where bones are located directly beneath the skin, such as
knees and ankles.
◗Select speed II (Fig. 5) for larger areas with stronger hair growth.
5Stretch the skin with your free hand to make the hairs stand
upright (Fig. 6).
6Place the epilating head (D) perpendicularly onto the skin so that
the epilating head (D) and the pain softener (E) are in proper
contact with the skin.
7Move the appliance slowly, with the pain softener (E) pointing
forward, against the direction of hair growth. Do not exert any
pressure (Fig.7).
8Stretch your leg when you are epilating the back of your knee.

ENGLISH 9
9Switch the appliance off by sliding the on/off switch (F) to O
(Fig.8).
Epilating armpits and bikini line
(Type HP6444 only)This appliance comes with precision cap (B).This
precision cap reduces the number of epilating discs that are active and
stretches the skin during epilating. It is particularly suitable when
epilating armpits and bikini line.You will get the best results when the
hairs are not too long (max. 1 cm).
1Switch the appliance off (Fig. 8).
2Slide the pain softener for epilating the legs (E) off the appliance
with your thumbs (Fig. 9).
3Fit the pain softener for epilating the armpits and the bikini line
(C) onto the appliance (Fig. 10).
4Place the precision cap (B) onto the appliance. (Fig. 11) The
precision cap (B) can only be fitted onto the appliance in one
way.
5Switch the appliance on by selecting the desired speed.We advise
you to use speed II (Fig. 5).
6Stretch the skin with your free hand (Fig. 6).
7Place the appliance perpendicularly onto your skin, without
exerting any pressure (Fig. 12).
8Make sure both the epilating discs (D) and the pain softener (E)
are in proper contact with the skin (Fig. 13).
9Move the appliance slowly over your skin against the direction of
hair growth.
Exfoliating (type HP6447 only)
Use the exfoliating head only on your legs, not on your armpits or
bikini line.

ENGLISH10
1Make sure the appliance is switched off.
2Remove the epilating head by pressing the ribbed section and
sliding it off the appliance in the direction of the arrow (fig.14).
3Remove the pain softener (fig.15).
4Slide the exfoliating head onto the appliance. It only fits onto the
appliance in one way (fig.16).
5Switch the appliance on.
6Choose speed I or II, depending on the required exfoliating
intensity.We recommend exfoliating each leg for 1-3 minutes.
- To obtain a good skin appearance, use the exfoliating head once or
twice a week.
- Don't use any cream, foam, gel or lotion just before or during the
exfoliation.
- Don't use the exfoliating head within two days after epilation.
- For hygienic reasons, the exfoliating head should only be used by
one person.
- We advise you to exfoliate before going to bed at night.Any skin
irritation that may develop will diminish overnight.
- After exfoliation, apply a mild cream or body milk to hydrate the
skin and improve its texture.
Cleaning
Do not use cleaning agents, scouring pads or cloths, petrol, acetone etc.
to clean the appliance. Regular cleaning and maintenance guarantees
the best results and a long life for your appliance.
1Switch the appliance off and pull the adapter (J) out of the wall
socket.
2(Type HP6444 only) Remove the precision cap (B) (Fig. 17).
3Remove the epilating head (D). (Fig. 14) Press the ribbed sections
and slide the epilating head off the appliance in the direction of
the arrow.