Philips MX2500D/78 Operating manual

MW
FRONT
RIGHT
FRONT
LEFT
REAR
RIGHT
REAR
LEFT
SUBWOOFER
FRONT
CENTER
Pr/Cr
P b /C b
Y
MX2500D
QUICK USE GUIDE
FRONT L
REAR R REAR L
CENTER
MW loop antenna
FM antenna
Composite
video cable
12nc : 8239 300 32901
FRONT R
Passive
Subwoofer
D
Helpful Hints
To obtain a better picture quality effect, you can
choose to connect an extra video connection if
your TV has the same input connector: Aor B.
If your TV has
this video input jack(s)
A
B
Use this video
cable (not supplied)
S-VIDEO
IN
COMPONENTVIDEO IN
ANTENNA IN
Do not switch the P-SCAN to ‘ON’ position, unless you have
connected the DVD system to a Progressive Scan TV using the
Component (Y Pb/Cb Pr/Cr) video jacks.
When listening to TV programmes, press TV button on the remote to
set the DVD system to TV mode in order for the sound to be heard.
For connecting to a VCR, see page 11 in the owner’s manual for more
details.
P-SCAN
OFF ON
If your TV has only
a single Antenna In
jack, you will need an
accessory RF
modulator. The RF modulator
converts the video from the
DVD system so it can play
through the TV’s Antenna
connector. Refer to your
owner’s manual for proper
connection (refer to page 9 in
the owner’s manual).
ABC
D
E
F
H
JG
G B
HCAJ
First connect ...
... then play
(see next page)

1
4
5
4 CHANNEL3
2
3
1ALL
ALL
Detailed playback features and additional functions are described in the
accompanying owner’s manual.
Playing a disc
1Press DISC on the remote control.
You can also press the SOURCE button on the front panel
until “DISC” appears on the display panel.
2Turn on theTV and select the correctVideo
In mode.
You should see the blue DVD background screen on the TV
(if no disc in the DVD system).
3Press OPEN/CLOSE 0on the front of the
DVD system and load a disc, then press
OPEN/CLOSE 0again to close the disc tray.
Make sure the disc label is facing up. For double-sided discs,
load the side you want to play face up.
4Press ÉÅ to start playback.
If a disc menu appears, use 3412buttons on the remote
to make the necessary selection, then press OK to confirm.
Or, use the numeric keypad on the remote to select features.
Follow the instructions given in the disc menu.
5To stop playback, press STOPÇ.
Make sure your DVD system and
TV are connected and turned on!
➠
TV SHAPE
TV SYSTEM
VIDEO OUT
SCR SAVER
DIGITAL OUT
CNTR DELAY
NIGHT MODE
REAR DELAY
TEST TONE
AUDIO
SUBTITLE
DISC MENU
PARENTAL
PASSWORD
DEFAULTS
MENU LANG
1
2
➠➠
Using the DVD setup menu
Check the AV (Audio/Video)
mode on yourTV.
* Usually this channel is between the
lowest and highest channels and may
be called FRONT, A/V IN, or VIDEO.
* Or, you may go to channel 1 on your
TV, then press the Channel down
button repeatedly until you see the
Video In channel.
* Or, your TV remote control may
have a button or switch that chooses
different video modes.
* Do not use channel 3 or 4 on the TV
unless you are using an RF modulator.
* See yourTV manual for more details.
No picture?