1. Technical Specifications,Connections,and Chassis Overview
2
1.Technical Specifications,Connections,and Chassis Overview
TPM1.0U LA
1.1 Technical Specifications
1.1.1 Technical Specifications
Index of this chapter:
1.1 Technical Specifications
1.2 Connections
1.3 Chassis Overview
Notes:
Figures below can deviate slightly from the actual situation,
due to the different set executions.
Specifications are indicative (subject to change)
Panel :LPL
Active Area :697.685mm (H) X 392.256mm
(V) (31.51" diagonal)
Outline Dimension :760.0mm (H) X 450.0mm (V)
X 48.0mm (D)
Pixel Pitch :0.17025mm(H) X 0.51075mm(V)
Pixel Format :1366 X 768 (WXGA), RGB
strip arrangement
Color Depth :8-bit, 16.7M colors
Luminance :500 cd/m2(Typ)
Backlight :18 EEFL
Response Time :10msec.
Viewing Angle :170/170 (L/R,U/D) (CR > 10)
Contrast Ratio :800:1
Tuning system :PLL
CCFL MTBF :50,000 hrs (min.)
Supoorted video fomats :720 x 480 @60i
720 x 240 @60p
640 x 480 @60p
720 x 480 @60p
800 x 600 @60p
1280 x 720 @60p
1024 x 768 @60p
1920 x 1080 @60i
1920 x 1080 @30P
1920 x 1080 @60P
1.1.2 Sound
Sound systems : Mono / Stereo / Virtual Surround
Maximum power : 2 x 5W
1.1.3 Miscellaneous
Power supply
AC-input : 90V ~ 264VAC, 50/60±3Hz
Normal Operation Power
Consumption : < 150W (LC320W01-SL06)
Standby power : < 1W (110V/60Hz only)
Power cord length : 1.8M
Power cord type : 3 lead with earth plug , plugable
(US type)
Power indicator : LED (On: Green, Standby: No light,
VGA mode Standby: Red)
Ambient conditions
Temperature : 0 to40°C
Humidity : 10 to 90% (non --condensing )
Power consumption
Normal Operation : < 150W (LC320W01-SL06)
Standby power : < 1W (110V/60Hz only)
1.2 Connections
1.2.1 Signal connector
FL3-26W /32W /37W /42W /47W I/O function is located
on TV module, including
Tuner: NAFTA.
HDMI IN1: HDMI input (TV digital interface support HDCP)
with digital audio or with AV IN3 audio R/L.
HDMI IN2: HDMI input (TV digital interface support HDCP)
with digital audio or with AV IN3 audio R/L.
AV IN3: Video3 (CVBS, RCA jack) and S-Video share with
same audio R/L (RCA jack ).
AV IN1: YPbPr component video1 (RCA jack) with audio R/L (RCA jack).
AV IN2: YPbPr component video2 (RCA jack) with audio R/L (RCA jack).
Side AV IN: Side Video (CVBS, RCA jack), Side S-Video and
HDMI (DVI) share with same audio R/L (RCA jack).
Headphone OUT : Audio R/L out (mini-jack)
SPDIF OUT : RCA jack
PC VGA: D-SUB 15 pins
PC Audio: Mini-jack
TUNER
Y2 Pr2 Pb2 L2 R2
AV2
Y1 Pb1 Pb2 L1 R1
AV1
D-Sub
HDMI1 HDMI2
RS232
For
service AV3
L3 S-Video
SPDIF
R3 CVBS
PC
Audio in
CN351 CN701 CN700 CN726 CN727 CN660 CN661 CN601 CN640 TU201
SideAV
S-VHS Right Left
CVBS Headphone
1.2.2. Input signal
TV Signal type:
RF Signal : Aerial input / 10mV(80dBuV)
Video signal : Video( RCA CVBS input) / 1Vpp
(300mV-sync, 700mV-video.)
S video input / 1VppY-signal, 300mVpp C-signal
COMP Video (YPbPr input)/ 1Vpp Y signal,
350mVpp Pb, Pr signal
HDMI : Digital interface with 4 channels TMDS signal
Audio signal : Audio (1) R/L for AV IN1 (Comp-video1).
Level: - Nominal : 0.5 V rms.
- Maximum : 1.5 V rms.
- Impedance > 10 k ohm.
Audio (2) R/L for AV IN2 (Comp-video2).
Level: - Nominal : 0.5 V rms.
-Maximum :1.5Vrms.
- Impedance > 10 k ohm.
Audio (3) R/L for AV IN3 (Video3 and S-video).
Level: - Nominal : 0.5 V rms.
-Maximum :1.5Vrms.
- Impedance > 10 k ohm.
Side Audio R/L for Side AV IN (Side Video and S-video).
Level: - Nominal : 0.5 V rms.
- Maximum : 1.5 V rms.
- Impedance > 10 k ohm
PC Signal type:
Analog Video : 0.7 Vp-p linear, positive polarity
Separate Sync. : TTL level, separate, positive or negative polarity
Audio signal : Mini-jack audio input,
Level: - Nominal : 0.5 V rms.
- Maximum : 1.5 V rms.
-Impedance > 10 k ohm.
Signal source : Pattern generator format as attachment.
(table 1 to 11)
Reference generator: CHROMA 2200 or 2250
Headphone output :
Audio: R/L output -10mW at 32ohm.
3.5mm stereo jack with switch
Impedance is between 8 ohm and 600 ohm
SPDIF output:
Level 0.5V ~ 1V Square Wave