Philips SmartBright Street BRP042 User manual

Installation Instruction
Philips Lighting India Limited
Installation
Type :
Light Source : LED’s
Voltage : 240 V, 50 Hz
IP Classification : IP-65
Net Weight : 0.8 kg
Max. Projected Area : .03 m²
Application : Outdoor use only
Mounting position : Horizontal
Application height : Upto 6m
Pole Outer Diameter : 32-40mm
BRP042
Brp 042 Street Lighting Luminaire
Dimensions
1. Connect the red wire to live, Black wire to Neutral and the Green-yellow wire to
ground. After joining Properly insulate the wires using good quality Electrical
insulation tape.
2. Unfasten the Check nuts and loosen the mounting screws to the required
height as per the pole size.(Fig 1)
3. Insert the pole up to the position shown in the drawing below (Fig 2)
4. Tighten both the mounting screws with tightening torque of 4Nm and then
tighten the Check nuts fully (Fig 3).
Un-screw
Screws & Check nuts
Pole should not go
beyond this point
FIG:1 FIG:2
FIG:3

CAUTION
1. Ensure Earthing is connected.
2. Ensure 3 core CABLE for Connections(diameter 5-7mm)
3. Cable Entry gland should be properly tightened.
4. Product should be operated between 100-300V a.c.
5. Use Surge protection (upto 10kV) to protect against surges
Use Type B+C surge type SPD in distribution box
FAILURE OF PRODUCT DUE TO NON COMPLIANCE TO ANY OF THE ABOVE,
VOIDS WARRANTY OF PRODUCT
to arrest switching and lighting surges.