Philips CSP7020/00 User manual

www.philips.com/welcome
Register your product and get support at
CSP620 CSP6920/CSP7020
www.philips.com/welcome
Register your product and get support at
EN User manual

b
e
a
d
c
a b
d
c
A
B

CSP620
CSP6920
Amplifier
Amplificador
Amplificador
Усилитель
ঘၿచ
Right
Derecha
Direita
Правый
Ⴛ
Left
Izquierda
Esquerda
Левый
ቔ
White lined
Con línea blanca
Revestimento branco
С белым покрытием
Ϧ೨์໙
Black
Negro
Preto
Черный
ޕ೨
White lined
Con línea blanca
Revestimento branco
С белым покрытием
Ϧ೨์໙
Black
Negro
Preto
Черный
ޕ೨
Right
Derecha
Direita
Правый
Ⴛ
Left
Izquierda
Esquerda
Левый
ቔ
e
f g
C

English
1. Important
Safety
Read and understand all instructions before you use the apparatus.•
If damage is caused by failure to follow instructions, the warranty does
not apply.
Use only the supplied mounting hardware for a safe and secure•
installation.
Do not continuously use the speaker system beyond the peak power•
handling capacity.
Keep credit cards, watches, recorded tapes etc. with magnetic coding•
away from the speaker system to prevent damage caused by the magnets
in the speakers.
Clean the apparatus with soft, damp cloth. Never use substances such•
as alcohol, chemicals or household cleaners on the apparatus.
Notice
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused if
disassembled by a specialized company. Please observe the local regulations
regarding the disposal of packaging materials, exhausted batteries and old
equipment.
Anychangesormodicationsmadetothisdevicethatarenotexpressly
approved by Philips Consumer Lifestyle may void the user’s authority to
operate the equipment.

2009 © Koninklijke Philips Electronics N.V. All rights reserved.
Specicationsaresubjecttochangewithoutnotice.Trademarksaretheproper tyofKoninklijkePhilips
Electronics N.V. or their respective owners. Philips reserves the right to change products at any time
without being obliged to adjust earlier supplies accordingly.
2.Your car stereo speakers
Congratulations on your purchase, and welcome to Philips! Tofully
benetfromthesupportthatPhilipsoffers,registeryourproductat
www.philips.com/welcome.
Introduction
With the speakers, you can enjoy high power music with vivid sound.
What’s in the box A
Check and identify the contents of your package:
aSpeakers (x2)
bGrille net + Frame (x2)
cSpeaker wire (x2)
dScrew (x8)
eShrapnel (x8)
3. Installation
A depth of at least 46mm is required to mount the speaker. Measure the
depth of the area where you are to mount the speaker, and ensure that
the speaker does not obstruct any other components of the car.

Option 1: Mount on door (front or rear) B
You can mount the speakers on the front/rear door of your car. a
Note
•Make sure that nothing obstructs around the mounting location of the door.
A hole for mounting may already be cut out of the inner panel of the door
•
(front or rear). In this case, you need to modify the board only.
Ensure that the speaker terminals, frame or magnet do not interfere with any
•
inner parts, such as the window mechanism in the door (when you open or
close the window), etc. Also ensure that the speaker grille does not touch any
innerttings,suchasthewindowcranks,doorhandles,armrestsetc.
1 Turnoffthecarignitionkey.
If the power is on, the click noise generated by the connection•
may damage the speakers.
2Cut out the mounting template from the packing box.
3Paste the template on the location selected for mounting the
speaker.
4Mark the cut-off hole and the 4 bolt holes. b
5Cut out the marked area and drill the bolt holes. c
6Remove the grille net. d
7 Stripthespeakerwiresandconnectthemtotheamplier. e
Black wire: connect to “-“ (negative) terminal•
Black (white lined): connect to “+“ (positive) terminal•

Note
Match the “left”, “right”, “+” and “-” terminals correctly. Revised polarity may
•
degrade sound quality.
Two4-ohmspeakers,wiredinstereo,presenta8ohmloadtoeachchannel
•
oftheamplier.Mosttwochannelampliersworkwellinthisconguration.
However, if two 4-ohm speakers, wired in parallel to a bridged two -channel
amplier,presenta2-ohmmonoloadtotheamplier.Most2-channel
ampliersdonotsupport2-ohmmonooperation!Amplierdamagemay
result!
8Mount on the speaker as shown below. f
9Press and insert the edges of the grille net. g
Tip
Thespeakergrillecanbemountedwithoutthegrillenet,ifyoulike.
•
Option 2: Mount on rear tray C
You can also mount the speakers into the surface of the rear tray.
Follow the steps in section “Option 1: Mount in door” to mount the
speakers into the rear tray:
4. Product information
Note
Product information is subject to change without prior notice.•

Model CSP620 CSP6920 CSP7020
Speaker type 16.5cm, 3-way
triaxial speaker
16x24cm, 5-way
coaxial speaker
18x26cm, 5-way
coaxial speaker
RMS power (Watts) 80W 80W 85W
Peak music power (Watts) 400W 480W 550W
Sensitivity (dB/W/m) 90dB 91dB 91dB
Frequency response (Hz) 35-32kHz 27-33kHz 26-33kHz
Impedance (ohms) 4 ohms 4 ohms 4 ohms
Magnet mass (Oz) 8.6Oz 22Oz 22Oz
Mounting depth (mm) 59mm 88.1 mm 85 mm
5.Troubleshooting
Tokeepthewarrantyvalid,nevertrytorepairthesystemyourself.
If you encounter problems when using this apparatus, go to the Philips
web site (www.philips.com/welcome). When you contact Philips, ensure
that the apparatus is nearby and the model number and serial number
are available.

© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
CSP620_6920_7020_00_UM_V1.0