Philips MCM1350 Product information sheet

MCM1350
2015 © Gibson Innovations Limited.All rights reserved.
This product has been manufactured by, and is sold under the responsibility of
Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation
to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke
Philips N.V. and are used under license from Koninklijke Philips N.V.
MCM1350_05_Short User Manual_V1.0
Switch to standby mode
Switch to ECO standby mode
Repeat steps 2-3 to set hour and minute.
www.philips.com/support
Always there to help you
Control play
Start, pause, or resume play.
Stop play.
/ Select an album or a folder.
/ Press to skip to the previous or
next track.
Press and hold to search
backward/forward within a
track.
Play a track or all tracks
repeatedly.
Play tracks randomly.
(not applicable for the
programmed tracks.)
VOL +/- Increase or decrease the
volume.
Mute or unmute sound.
SOUND Select a preset sound equalizer.
DISPLAY Adjust display brightness.
Question?
Contact
Philips
Question?
Contact
Philips
Short User Manual
• Make sure that you have set the clock correctly.
• Repeat steps 2-3 to set minute, select a source, and set
the alarm volume.

Press to select the sleep timer period.
When [OFF] (off) is displayed, the sleep timer is deactivated.
Specifi cations
Amplifi er
Total Output Power Maximum 30 W
Frequency Response 60 Hz - 20 kHz; ±3 dB
Signal to Noise Ratio ≥75 dBA
Total Harmonic Distortion <1%
Aux Input 600 mV ± 100 mV RMS
22 kohm
Speakers
Speaker Impedance 4 ohm
Speaker Driver Full range 3.5"
Sensitivity 83 ± 3dB/m/W
Tuner (FM)
Tuning Range 87.5-108 MHz
Tuning grid 50 KHz
Sensitivity
- Mono, 26dB S/N Ratio
- Stereo, 46dB S/N Ratio
<22 dBf
<45 dBf
Search Selectivity <30 dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio >45 dB
USB
USB Direct Version 2.0 Full Speed
Disc
Laser Type Semiconductor
Disc Diameter 12 cm/8 cm
Support Disc CD-DA, CD-R, CD-RW,
MP3-CD
Audio DAC 24 Bits/44.1 KHz
Total Harmonic Distortion <3% (1 KHz)
Frequency Response 20 Hz - 20 kHz
(44.1 KHz)
S/N Ratio ≥80 dBA
General information
AC power 100-240 V~, 50/60 Hz
Operation Power Consumption < 20 W
Eco Standby Power
Consumption
< 0.5 W
Dimensions
- Main Unit (W x H x D)
- Speaker Box (W x H x D)
180 x 121 x 227 mm
120 x 195 x 143 mm
Weight
- Main Unit
- Speaker Box
1.54 kg
0.81 kg x 2
To download the full user manual, visit www.philips.com/support.
Safety
Read and understand all instructions before you use this micro
music system. If damage is caused by failure to follow the
instructions, the warranty does not apply.
This ‘bolt of lightning’ indicates uninsulated material within the
device may cause an electrical shock. For the safety of everyone in
your household, please do not remove the covering.
The ‘exclamation mark’ calls attention to features for which you
should read the enclosed literature closely to prevent operating and
maintenance problems.
WARNING: To reduce the risk of fi re or electric shock, the device
should not be exposed to rain or moisture and objects fi lled with
liquids, such as vases, should not be placed on the device.
CAUTION:To prevent electric shock, fully insert the plug. (For
regions with polarized plugs:To prevent electric shock, match wide
blade to wide slot.)
Warning
•Never remove the casing of this apparatus.
•Never lubricate any part of this apparatus.
•Never look into the laser beam inside this apparatus.
•Never place this apparatus on other electrical equipment.
• Keep this apparatus away from direct sunlight, naked fl ames or heat.
•Ensure that you always have easy access to the power cord, plug or
adaptor to disconnect the apparatus from the power.
• The device shall not exposed to dripping or splashing.
• Do no place any source of danger on the device (e.g. liquid
fi lled objects. lit candles).
• Where the MAINS plug or an appliance coupler is used as
the disconnect device, the disconnect device shall remain
readily operable.
• Make sure that there is enough free space around the
product for ventilation.
• Battery usage CAUTION – To prevent battery leakage which
may result in bodily injury, property damage, or damage to
the unit:
• Install all batteries correctly, + and - as marked on the unit.
• Do not mix batteries (old and new or carbon and
alkaline, etc.).
• Batteries (packed or installed) shall not be exposed to
excessive heat such as sunshine, fi re or the like.
• Remove batteries when the unit is not used for a long
time.
• Only use attachments/accessories specifi ed by the
manufacturer.
Notice
Any changes or modifi cations made to this device that are not
expressly approved by Gibson Innovations may void the user’s
authority to operate the equipment.
Compliance
This product complies with the radio interference requirements of
the European Community.
This apparatus includes this label:
Care of the environment
Disposal of your old product and battery
Your product is designed and manufactured with high
quality materials and components, which can be recycled
and reused.
This symbol on a product means that the product is
covered by European Directive 2012/19/EU.
This symbol means that the product contains batteries
covered by European Directive 2013/56/EU which cannot
be disposed of with normal household waste.
Inform yourself about the local separate collection system
for electrical and electronic products and batteries. Follow local
rules and never dispose of the product and batteries with normal
household waste. Correct disposal of old products and batteries
helps prevent negative consequences for the environment and
human health.
Removing the disposable batteries
To remove the disposable batteries, see battery installation section.
Environmental information
All unnecessary packaging has been omitted.We have tried to
make the packaging easy to separate into three materials: cardboard
(box), polystyrene foam (buffer) and polyethylene (bags, protective
foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
Important notes for users in the U.K.
This information applies only to products with a UK mains plug.
This product is fi tted with an approved molded plug. If you replace
the fuse, use one with:
• the ratings shown on the plug,
• a BS 1362 approval, and
• the ASTA approval mark.
Contact your dealer if you are not sure about what type of fuse to use.
Caution:To conform with the EMC directive (2004/108/EC), do not
detach the plug from the power cord.
How to connect a plug
The wires in the mains lead are coloured with the following code:
blue = neutral (N), brown = live (L).
As these colours may not correspond with the colour markings
identifying the terminals in your plug, proceed as follows:
• Connect the blue wire to the terminal marked N or coloured
black.
• Connect the brown wire to the terminal marked L or
coloured red.
• Do not connect either wire to the earth terminal in the plug,
marked E (or e) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent. see Copyright
Act 1956 and The performer’s Protection Acts 1958 to 1972.
The making of unauthorized copies of copy-protected material,
including computer programs, fi les, broadcasts and sound recordings,
may be an infringement of copyrights and constitute a criminal
offence.This equipment should not be used for such purposes.
Care for your product
• Do not insert any objects other than discs into the disc
compartment.
• Do not insert warped or cracked discs into the disc
compartment.
• Remove the discs from the disc compartment if you are not
using the product for an extended period of time.
• Only use microfi ber cloth to clean the product.
Note
•The type plate is located on the back of the product.
Tune to FM radio stations Store FM radio stations automatically Store FM radio station manually