Philips A10E Operating and installation instructions

Published by RB 0267 Service PaCE Printed in the Netherlands Subject to modification EN 3122 785 40650
©
Copyright 2002 Philips Consumer Electronics B.V. Eindhoven, The Netherlands.
All rights reserved. No part of this publication may be reproduced, stored in a
retrieval system or transmitted, in any form or by any means, electronic,
mechanical, photocopying, or otherwise without the prior permission of Philips.
Colour Television Chassis
A10E
AA 02.01
Introduction
In this Service Information, additional info is given on the A10E DTV
(Digital TV) concerning the models 28/32DW6557, launched on the
market in week 227. The A10E DTV is in fact an A10E-chassis with an
integrated S5.2 Digital Board (the same as used in settop boxes).
Only new items, compared to the standard A10E manual (3122 785
10430) are mentioned here.
The S5.2 module is regarded as a black-box, therefore the only items
described in this document are the DTV Interface panel and Power
supply. For more info on the S5.2 Digital board see the MG4.1E Service
Manual (3122 785 10650).
Contents
• Warnings
• Directions for Use
• Mechanical Instructions
• Wiring Diagram
• Electrical Diagrams and PWB’s
• Spare Parts List

EN 2 A10E AA 02.01
Warnings
•Non mains-isolated (=hot) parts:
On the Power Supply of the Digital Board, 2 areas are not isolated
from the mains. See grey parts in figure 1.
Figure 1
Mechanical Instructions
Note: Figures can deviate slightly from the actual situation, due to
different set executions.
Removing the Digital TV module
1. Before you can access the Digital TV module, remove the rear
cover.
2. Disconnect all cables on the Digital TV module.
3. Take the module out of the set.
Removing the Digital Board from the bracket (see fig. 2)
1. Remove the I/O cover plate by lifting the upper and lower snap
hooks [1]. Then remove the cover plate [2].
2. Now the complete Digital Board PWB can be slid out of its bracket
[3]. If the board blocks, it is possible due to connector 1000, which
can hamper the movement of the panel. Press the board a little
upward near this connector and slide it out.
Figure 2
CL 06532106_004.eps
010800
POWER SUPPLY
DIGITAL BOARD
"HOT" PART
CL 06532106_007.eps
030800
4
32
1
1

Direction for Use EN 3A10E AA 02.01
Direction for Use

Direction for Use
EN 4 A10E AA 02.01

Direction for Use EN 5A10E AA 02.01

Direction for Use
EN 6 A10E AA 02.01

Direction for Use EN 7A10E AA 02.01

Direction for Use
EN 8 A10E AA 02.01

Direction for Use EN 9A10E AA 02.01

Direction for Use
EN 10 A10E AA 02.01