Philips DCD778 User manual

Use 1/4"
drill
DC
VIDEO
IN
AUDIO
R
IN
L
TV
ANT
Recommended depth of cabinet
at the rear to allow for connections
2.5"
Mount it
Ask a friend to help out. An extra hand to hold the unit makes mounting easier
and quicker.
A
•Cut the template to fit inside the cabinet.
•Align the template border marked "FRONT"
along the front edge of your cabinet.
•Use adhesive tape to fix the template.
•Drill 1/4 inch holes, as marked Xon the tem-
plate.
•Remove the template when you finish drilling.
B
Using the spacers
On the spacers, there are 4 pairs of notch length
options. Depending on the thickness of you cabi-
net bottom (with/ without an overhang), these
notch lengths correspond to the 4 notch height in
the space holders, and allow you to adjust to the
best height to help you mount the unit.
•Measure the height of the cabinet bottom
and/overhang.
•Tu rn the spacer counterclockwise to determine
which of the 4 heights is most suitable: Low •
• High. Align to the arrow indication.
•Insert the spacers accordingly.
C
•Manually fasten the 4screws down into
the spacer holder holes to mount your
set. Start screwing at opposite corners of
the unit for better support.
Tip
To prevent damage to your set, do not use an
electric drill to secure screws when mounting!
– If the overhang is more than 1 1/4 inch, use longer screws
(not included).
Template
A
H
L
Spacer
L (Low)
L••H (4 heights)
Arrow
B
C
Tip
– Clean the bottom of the cabinet surface and also empty your cabinet
before mounting.
– Place the unit in a clean, safe place when drilling to avoid wood
shavings dropping into the ventilation slots.
– Use a nail to start each drill hole.
– Drill from the bottom upwards if you do not have enough room inside
the cabinet.
– Hold your drill firmly at 90owith the cabinet bottom and drill holes at
low speed.
– Clear wood shavings.
Mount_DCD778 9/2/07 19:30 Page 1