PhotonStar Ceiling Star SM User manual

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
PLEASE RETAIN INSTRUCTIONS FOR FUTURE REFERENCE
Ceiling Star SM
Installation Instructions
IMPORTANT PLEASE READ
BEFORE INSTALLATION
 Before commencing installation ensure the relevant mains supply
has been safely isolated.
 Installation should be carried out in accordance with the latest
relevant wiring regulations for the specific country/region.
 Installation should be carried out by a qualified electrician.
 Ensure all electrical connections are tight with no loose strands,
including factory made connections.
WARNINGS
 Use only with the approved driver for this product.
 This luminaire is for indoor use only.
 IMPORTANT The LED driver must not be covered by ceiling insula-
tion material; this will reduce the units operational lifetime, invali-
date the guarantee and may cause a risk of fire.
This install manual covers the following products:
CS-SM-MW/xxx-
xxx-xx-xx/xx
P1 of 2 Revision:1 12/04/11
Max. 10m
For screwing directly to ceiling:
 Connect LED driver to mains.
 Locate LED driver up to 10m away from fitting and feed
connector through ceiling.
 Connect luminaire to LED driver
 Locate appropriate fixing screws at 85mm centres. Do not
tighten fully, however there should be sufficient friction
between the screw heads and the keyhole slots to hold the
fixture in position.
 Use a clockwise twist to secure the luminaire to the screws.
 Tighten screws if necessary.
220-240V
Photonstar LED Ltd.
Unit 8, Westlink,
Belbins Business Park
Romsey
Hampshire
SO51 7JF
UK
Tel: [phone]
Email: [e-mail]
Web: www.photonstarlighting.com
1. 2. 3.
To mains
Ensure mains is isolated
Red/black mains cable
4.

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
PLEASE RETAIN INSTRUCTIONS FOR FUTURE REFERENCE
P2 of 2 Revision:1 12/04/11
To driver.
Max. 10m
For conduit (BESA) box with 2”/50.8mm centres:
 Connect driver to mains.
 House LED driver up to 10m away from fitting and feed wire through
conduit to conduit box.
 Attach a PhotonStar conduit box adaptor plate to the conduit box
using two M2.5 screws.
 Connect the luminaire to the LED driver
 Secure the luminaire to the adaptor plate using the two protruding
screws and twist clockwise to lock into place.
 Tighten if necessary.
220-240V
Photonstar LED Ltd.
Unit 8, Westlink,
Belbins Business Park
Romsey
Hampshire
SO51 7JF
UK
Tel: [phone]
Email: [e-mail]
Web: www.photonstarlighting.com
1. 2. 3.
5.
4. 6.
Ensure mains is isolated