7
To force unit to connect back to server:
1. MENU to the Press UP Arrow to Callback screen.
2. Press the UP arrow.
3. Screen will say “Connecting to . . .”.
4. When connected to server screen will display “Active Connection . . .”.
5. Screen will return to main LCD screen when completed.
To change Output A or B and Input A or B BGM Volume:
1. MENU to the appropriate volume screen.
2. Press the UP arrow to increase or DOWN to decrease the volume
3. Press MENU when completed to save setting.
To take unit out of WiFi :
1. MENU to the WiFi Status screen.
2. Press the UP or DOWN arrows to change from ON to OFF.
3. Press SELECT.
4. Press UP to conrm setting.
5. Unit will reboot into Wired Mode if conrmed from previous step.
To place unit in WiFi through LCD/Keypad:
1. MENU to the Press Select to Scan for WiFi screen.
2. Press SELECT.
3. Screen will show Scanning for WiFi . . . This process will take about 30 seconds.
4. Press the UP and DOWN arrows to show WiFi networks found.
5. Press SELECT to choose the WiFi network.
6. Enter in Password for chosen WiFi Network.
a. Display will ash and show current location.
b. UP and DOWN arrows will change currently selected character.
c. Hold the SELECT and UP or DOWN arrow to move to next or previous character.
7. Press MENU to complete password entry.
To set IP Mode:
1. MENU to the IP Mode screen.
2. Press UP or DOWN to chose DHCP to STATIC.
3. Press SELECT to set DHCP or STATIC. Note unit will reboot after this setting.
To change IP, Subnet, Gateway, Connect-Back & CB Ports:
1. MENU to the IP, Subnet or Gateway screen.
2. Press SELECT and the rst octet will be able to be edited.
3. Press the UP or DOWN arrows to choose the new octet setting.
4. Press SELECT to move to the next octet group.
5. Once the last octet is chosen, then press SELECT to set the address.
To Format Unit & Reboot IP Mode:
1. MENU to the Format Unit And Reboot screen.
2. Press SELECT.
3. Press the “Pattern” to format and reboot or the MENU button to cancel.
LCD Menu
