Pillar Laguna User manual

INSTALLATION INSTRUCTIONS
Laguna Concertina Door
LAGUNA DOOR INSTRUCTION PAGE 1
Handle Pin x 2Handle x 2
Top Track x 1 Magnetic Plate x 1
Screw A x 7
(Headrail - Mag. Plate)
Connector x 1Top Glide x 7
COMPONENTS
Screw B x 6
(Side Panel)
T-Top Glide x 1
TOP TRACK

Pivot Top Track out from
frame to enable the door
panels to slide onto track.
Align panel top Glides
with track channel and
insert into top track.
Re-align Top Track with
doorway/frame and secure
firmly into place with
additional screws (A).
Centre Top Track in
doorway and secure with a
single screw (A) in the
centre to allow track to
pivot/turn.
LAGUNA DOOR INSTRUCTION PAGE 2
STEP 1.
STEP 2.
STEP 3.
STEP 4.
Place Top Glides over each
full panel centre hole. Ensure
they clip into place.
Secure T-Top Glide into place
using Connector piece.
T-TOP GLIDE
TOP GLIDES

Slide door against
non-opening side of
frame and allow to hang
naturally. Fix door to
frame using screws (B) at
pre-drilled locations
Close door to mark Magnetic
Plates location aligned with
door magnets and secure
into Frame using screws (A)
STEP 5.
STEP 6.
STEP 7.
STEP 8.
(B)
LAGUNA DOOR INSTRUCTION PAGE 3
Install the handle through the
door using the pins included.
Your new Concertina door is
now ready for use.