PinSightz CM4949PRO User manual

www.pinsightz.com
0
OPERATING INSTRUCTIONS
Features:
21mm Objective Lens
6x Magnification Power
7.2°View Angle
16mm Pupil Distance
Precision To +/-1 M
Maximum Range :
CM4949PRO 600M
Closest distance :
CM4949PRO 4M
Speed range:0-300KM/H
3V Battery (CR2)
Waterproof
Size:
L:97mm (does not include eyepiece)
106mm (includes eyepiece)
W:35mm
H:73mm (front)
68mm (rear)
Weight: 5.4 oz

www.pinsightz.com
5
2-2 FLAGPOLE LOCK
Principle:
In this mode, the point D may be isolated from several points in the
background, while keeping only the distance d1 to the point, to
achieve the automatic locking flagpole distance. The other goals are
shielded behind the flagpole.
“Flagpole Lock”screen

www.pinsightz.com
6
Select the “Flagpole Lock” screen. Aim the device at the flagpole,
ensuring that the pole is in the center of the screen, and lined up with
the vertical arrows. Press and hold the power button to start the
flagpole scan function. A box will appear in the center of the screen.
When the box begins to flash, and a second box appears around the
flag symbol, the flagpole distance has been found. The measurement
will appear in top of the screen.
2-3 GOLF DISTANCE CORRECTION:
Press the mode button until the “Golf
Distance Correction” screen appears.
Press the power button to start
flagpole scanning. The distance to the flagpole appears, followed by
the slope from the rangefinder to the flagpole. The trajectory can then
be calculated using these two values.
Principle: Distance and slope will affect flight calculations.

www.pinsightz.com
7
A positive (uphill) slope
1: Golf ball flight path, without distance correction
2: Golf ball flight path, with distance correction
Point B is the pole position. User must account for the slope to
correctly determine the distance needed to reach the pole.
With a positive slope, the arc should be greater than when on a
horizontal plane.
A negative (downhill) slope
1: Golf ball flight path, with distance correction
2: Golf ball flight path, without distance correction
Point B is the pole position. With a negative slope, the arc
should be less than when on a horizontal plane.

www.pinsightz.com
10
2-6 VERTICAL HEIGHT MEASUREMENT
The rangefinder measures the distance
between two vertical points (Top and Bottom), and the
angle (a) between those points, to calculate
the vertical height (VH).
Principle:
Once the aiming point is aligned at the bottom of the measured object,
hold down the power button . "Scan" and "Bottom" appear on
the screen, and the measurement to the bottom is found. When the
screen displays “Top”, aim the center box at the top point you wish to
measure. The vertical height measurement will display once both
points are measured and calculations are complete.
Table of contents