1
3
2
4
x 2PoE Ethernet Extender Power Cord Device Mounting Kit Terminal Block
Screws
x 2 x 1 x 4
x 12
AC Power Jack
1.
2.
DIP 1 DIP 2 DIP 3 DIP 4
ON CPE Asymmetric 6 dB
OFF CO Symmetric 9 dB
4. 1/2/3/4 LEDs:Description of link LED status:
LED Off Flashing On
Status No Link Data Transmitting Idle
LED\Status
CO CPE
PoE Ethernet Extender
PM342E
Quick Installation Guide
PoE Ports(RJ-45)x4
LED indicator
DIP Switch
1
4
3
2
5
6. Frame ground:Grounding connection to protect from lightning.
Telephone line
(RJ11)+Terminal Block
Frame ground
6
3. DIP switch
Step1. Check the package contents
Step2. Product Appearance
Step3. Installation
Front Panel
Back Panel
PoE Network connectors(RJ45):Provides 4 PoE port to support 4 PoE network devices that meet
IEEE802.3af standard.
Telephone line connectors(RJ-11) and Terminal Block:The PM342E are working in pair.
A telephone line / twisted pair links the two PM342E, so that they can communicate to each other.
Functions CPE/CO Transmission Mode1 Transmission Mode2 S/N
Fast
Interleave
Description of all LEDs status:
Off On Flashing
Power off Power on
Connected Connecting
5.
V1.3
3
2
12
3
4
5
6
6
12
3
4
( Remote site)
( Remote site)
( Local site)
( Local site)
Remote site
(CO)
Local site
(CPE)
AC Power Jack:AC 90V~240V
Set Remote Site PM342E DIP1 switch to “Off” Local Site PM342E DIP1 switch to “On”.
Connect two PM342E with phone line cord or twisted pair.
Connect power cord to local site of PM342E and switch ON.
-The “PW” LED is “On”.
-The “CPE” LED for Remote Site PM342E will be “Off” while the other one is “On”.
-The “LINK” LED for both PM342E will be slow flashing at this point and then become solid “On” which
indicates the two PM342E are connected by twisted pair cable .
Connect LAN port to a network device for each side of PM342E.
PW
CPE
Link
(It will take 3 minutes to estanblish connection of two devices)
★Default
★ ★ ★
