Platinum PT-A5SBC2G User manual

PTA5SBC2G / PTA5SBC2U
MADE FOR
iPHONE 5/iPHONE 5s
POWER CASE
QUICK SETUP GUIDE
Before using your new product,
please read these instructions to prevent any damage.
INSERTING YOUR iPHONE
Note: This case is partially charged out of the box.You
may want to charge it fully before use. See Charging Your
Case for more information.
1Pull out the sliding connector on the bottom of
the case.
2Insert the top of your iPhone into the case (A),
then insert the bottom (B).
3Push the sliding connector back into the case so
it ts securely inside your iPhone’s charging port.
Thank you for purchasing a Platinum Power Case
for iPhone 5 and iPhone 5s. This case gives your
phone additional battery power for your on-the-go
life.
PACKAGE CONTENTS
• Power case
• Audio adapter
• Micro USB charging cable
• Quick Setup Guide
FEATURES
• Increases the battery life of your iPhone by up to
90% (or 9 hours of additional talk time)
• Unique one-piece design is easy to get your
iPhone in and out as needed
• Fully protective shell helps safeguard your
iPhone from everyday wear
• LED indicator and power switch save power
until you really need it
• Built-in short circuit, over-charge, and
temperature protection

V2 ENGLISH 14-0364
USING YOUR CASE
1Slide the power switch on the back of the case to
green.The charging indicator appears on your
iPhone screen.
2When you are nished, slide the power switch to
red to turn o the case.Your iPhone will be
powered only by its internal battery.
USING YOUR AUDIO ADAPTER
• Most 3.5 mm audio cables will t in your
iPhone’s audio jack. If a cable does not t, connect
the audio adapter to your iPhone’s audio jack and
to the audio cable you want to connect to your
phone.
REMOVING YOUR iPHONE
1Slide the power switch to red to turn o the case
2Pull out the sliding connector.
3Grasp the sides of your iPhone and lift it out of
the case.
CHARGING YOUR CASE
It takes about 3 to 4 hours to charge your case
when it’s completely drained. To check your case’s
battery level or charging status, press the Charge
Level button. The charge level lights show your
case’s battery level.
• Plug the charging cable into the micro USB port
on the bottom of the case and a USB power
source (such as a laptop or wall charger).
The charge level lights show your battery level
for 20 seconds, then turn o.
TROUBLESHOOTING
What if my phone doesn’t charge?
• Make sure the case is correctly connected to the
power port on your iPhone.
• Make sure you’ve charged your case.
• Make sure the power switch on your case is
turned to green (on).
Audio
adapter
Power switch Charge level button
Charge level lights
2 lights 50%
1 light 25%
4 lights 100%
3 lights 75%
CHARGE LEVEL LIGHTS
SPECIFICATIONS
Compatibility: iPhone 5 or iPhone 5s
Battery: Lithium Ion
Battery Capacity: 2300mAh
FCC
FCC Caution: Changes or modications not expressly approved by the part responsible
for compliance could void the user’s authority to operate the equipment.
FCC Statement:This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1)This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
CAN ICES-3 B/NMB-3 B
Caution: Risk of re; Do not short circuit, crush, disassemble and dispose of in re.
ONE-YEAR LIMITED WARRANTY
CONTACT PLATINUM
For customer service, call 1-800-499-3964.
“Made for iPhone”means that an electronic accessory has been designed to connect specically to
iPhone, and has been certied by the developer to meet Apple performance standards. Apple is not
responsible for the operation of this device or its compliance with safety and regulatory standards.
Please note that the use of this accessory with iPhone may aect wireless performance.
iPhone is a trademark of Apple Inc., registered in the U.S. and other countries.
The Pt logo is a registered trademark of BBY Solutions, Inc.
PLATINUM is a trademark of Best Buy and its aliated companies. Registered in some countries.
Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2014 Best Buy. All rights reserved.
Made in China