Playcore ultraPLAY NatureROCKS 5TSL User manual

ELEVATION
PLAN
Tree Slice Steppers
5TSL

GENERAL NOTESINSTALLATION INSTRUCTIONS
• Due to variables in local soil
conditions, footing sizes may vary to
meet local codes.
• Actual on-site conditions may vary
and may require modifications to
installation method.
• Use care and caution while handling
play pieces. Make sure all points
of contact are protected from lifting
straps or other machinery that may
damage the piece.
• Bracing materials may be required
during installation.
Tools Required:
• Shovel /Auger
• Nylon lifting strap, minimum 8’ length
Note: Rated for 500 lbs. minimum
• Concrete
Note: Rated for 2,500 psi minimum
Weight: 90-125 lbs. per Tree Slice Stepper
Step 1: Thoroughly inspect all pieces before unloading for damages incurred
during shipping.
Step 2: Establish layout of Tree Slice Stepper and dig footing holes.
Step 3: Place 10” diameter Sonotube into footing hole. Sonotube height should
be 10” above grade for 12” of play surfacing. Fill Sonotube with concrete.
Step 4: While concrete is still wet, thread J-bolts (2 per Tree Slice Stepper) into inserts,
then carefully place Tree Slice Stepper into Sonotube. Make sure piece is
centered and level.
Step 5: Once concrete has hardened, remove all remaining packaging materials
and inspect piece for blemishes. Use included touch-up kit as needed.