Playskool Dora the Explorer Sit 'n Spin 34676 User manual

OVER 18 Months
to 5  Years
34676
PLAYSKOOL.COM
FOR NEW PRODUCTS AND OFFERS
PLAYSKOOL.COM
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-PLAYSKL
© 2005 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
34676 P/N 6499290000
Thank you for choosing this PLAYSKOOL brand product!
Use a Phillips/cross head screwdriver
(not included) to loosen screw in battery
compartment door located on the bottom of
the SIT ‘N SPIN base (screw remains attached
to door). Remove door. Remove and discard
old batteries. Insert 2 x 1.5V “AA” or R6 size
batteries. Alkaline batteries recommended.
Replace door and tighten screw.
TO REPLACE BATTERIES
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and
battery manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
!
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert them
correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries, or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away from
other electrical equipment. Reset (switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always
remove from the product before recharging. Recharge batteries under adult supervision. DO
NOT RECHARGE OTHER TYPES OF BATTERIES.
!
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy, and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Sit ‘n Spin®
Includes: SIT ‘N SPIN base, center post (2 pieces),
3 screws, turn handle and instructions.
Adult assembly required.
Phillips screwdriver (not included) needed for assembly.
Batteries included.
Replace with 2 x
1.5V “AA” or R6
size batteries.
Alkaline batteries
recommended.
Phillips/cross head
screwdriver needed
to replace batteries.

ASSEMBLY: Here are the easy-to-follow instructions for assembling your
DORA THE EXPLORER SIT ‘N SPIN toy. Please follow assembly
instructions in proper order for best results.
Keep the fun spinning in “Music”, “Giggle”, or “Counting”
mode! Here are some play suggestions to get you started:
PLAY FEATURES:
1. Connect the right side and
left side of the center post
by snapping the two pieces
together. This is a one-time
assembly.
2. Use a Phillips (cross) head
screwdriver (not included)
and 2 screws (included) to
connect the turn handle
to the top of the center
post. The screws connect
on the sides of the turn
handle as shown.
3. Place the center post/
turn handle into the SIT
‘N SPIN base as shown.
Flip the SIT ‘N SPIN
base over and use a
Phillips (cross) head
screwdriver and 1
screw (included)
to connect the
center post/
turn handle
to the base.
2.
NOW YOU’RE READY TO PLAY!
“Music”, “Giggle”, or “Counting” mode – it’s your choice!
1. Push the moon-shaped button on top of the SIT ‘N SPIN base or spin the base to
start Dora’s theme song. Once the song is finished, you may press the moon-shaped
button on the top of the SIT ‘N SPIN base to toggle through modes, or you may
continue spinning and Dora will automatically cycle through each mode.
Music Mode
Dora will start to talk and encourage a sing along.
Giggle Mode
In this mode, Dora will giggle and laugh as your child spins ‘round and ‘round!
Counting Mode
In this mode, Dora will count each revolution your child makes on the SIT ‘N SPIN.
Your child can count along in English and Spanish! Once Dora has counted up to five,
she returns to the initial “Music” mode.
NOTE: Toy will automatically cycle through all modes of play, even if moon-shaped
button is not pressed. You may manually repeat any mode by pressing the moon-
shaped button twice.
2. This toy also features “sounds off” mode for quiet play! Simply move the switch at
the bottom of the toy to “off”.
3. After 30 seconds of inactivity, the toy will automatically shut off. To play again,
simply spin the base. When storing, make sure the three-position switch is moved
to “off” position to conserve battery life.
1.
Press Here
Note: Check to be sure that
all assembled parts
are securely attached
before using the toy.
a.
b.
Note: For best performance,
child should be seated
on one of the two
designated seating
areas marked with the
yellow star.
seating areas
NOTE: This toy is packaged in “demo” mode. To enable full play features, switch to “play”
mode located on the underside of toy.
PLAYOFFDEMO