BACK SPLASH
BASIN & TOP
MARBLE TOP
FITTING & CARE GUIDE
PLEASE READ ALL THE INSTRUCTION FULLY BEFORE PROCEEDING.
WE HAVE TAKEN GREAT CARE TO ENSURE THAT THIS PRODUCT REACHS YOU IN GOOD CONDITION. HOWEVER
SHOULD ANY PARTS BE DAMAGED OR MISSING PLEASE CONTACT YOUR LOCAL BRANCH.
WHEN FITTING, MAKE SURE TO PROTECT THE SURFACE FINISH AGAINST SCRATCHES AND MARKS THAT CAN BE
CAUSED BY INSTALLATION OR ANY ROUGH SURFACES.
FIT ANY ADDITIONAL PRODUCTS SUCH AS THE WASTE AND TAPS (NOT SUPPLIED) AS PER THE
MANUFACTURE'S INSTRUCTIONS.
NO REFUNDS OR REFITTING COST WILL BE GIVEN IF INCOMPLETE OR DAMAGED GOODS ARE FITTED.
MAKE SURE THAT THE CABINET IS LEVEL AND
FLUSH BEFORE PROCEEDING WITH ANY
INSTALLATION.
IF ANY FURTHER WORK AROUND THE
PRODUCT NEEDS TO BE CARRIED OUT, SUCH
AS TILING OR FITTING OF A MIRROR, PROTECT
SURFACES WITH A COVER OR AN OLD BLANKET.
ENSURE ALL SURFACES THAT ARE GOING TO
COME INTO CONTACT WITH THE SILICONE ARE
CLEAN AND DIRT FREE.
2
1
4
RUN A SMALL BEAD OF SILICONE AROUND THE
TOP EDGES OF THE CABINET WHERE THE TOP
& BASIN SITS. YOU MAY ALSO WANT TO APPLY
SOME EXTRA SILICONE OVER THE CABINET'S
TOP.
CAREFULLY PLACE THE TOP & BASIN ONTO
THE CABINET ENSURING ALIGNMENT IS
CORRECT.
ANY EXCESS SILICONE SHOULD BE CLEANED USING A SOFT DAMP CLOTH WITH COMMON DETERGENT.
DO NOT USE AN ABRASIVE AGENT.
ALLOW 24 HOURS FOR SILICONE TO CURE BEFORE USE.
5
CARE & MAINTENANCE
CLEAN THE PRODUCT WITH WARM SOAPY WATER OR A VERY MILD DETERGENT.
DO NOT USE DETERGENTS OR ABRASIVE CLEANERS.
SMALL MARKS AND MINOR SCRATCHES CAN BE BUFFED OUT USING A FINE T-CUT COMPOUND.
DO NOT POUR BOILING WATER OR STAND VERY HOT OBJECTS ON THE SURFACE AS THIS CAN DAMAGE THE
FINISH.
IF YOUR BACK SPLASH IS LOOSE, PLACE THE
BASIN AND TOP INTO POSITION ON THE
CABINET ENSURING LEVEL AND SQUARE.
RUN A BEAD OF SILICONE ALONG THE UNDER
SIDE OF THE BACK SPLASH AND GENTLY
POSITION AS REQUIRED.
CLEAN ANY EXCESS SILICONE USING A SOFT
DAMP CLOTH AND COMMON DETERGENT.
3
