Plyroom A4 Drawers User manual

PLYROOM
A4 Drawers
Thank you for choosing this product to be a part of your home.
Each Plyroom piece is made for life from sustainably forested materials. Your choice is helping support
environmental initiatives through our contribution of 1% of our sales revenue to 1% for the Planet.
Share your space with us #plyroom
@plyroom
www.plyroom.com.au
INTENTIONALLY SIMPLE
 HONEST DESIGN
This product is designed with a modern interpretation of mortise and tenon joinery,
the oldest and strongest form of joinery used by carpenters for thousands of years.
The precise interlocking parts are displayed throughout, and the pieces fit together
like a jigsaw, emphasising the characteristics of the natural materials used.
Each mortice and tenon join is locked in place with a
handmade oak dowel.
MINIMAL PACKAGING
You might notice that your item is packaged simply. This is intentional to minimise
waste as much as possible. The plastic wrapping used can be recycled at many
recycling centres rather than going to landfill.
ASSEMBLING YOUR FURNITURE
→Do
We ask that you take your time in assembling this piece of furniture. All pieces are
designed to lock together with precision.
Use a mallet to press mortise and tenon joins together so they are flush. If you don’t
have a mallet a hammer covered with a soft towel is fine.
Check all joins are flush before inserting the oak dowels.
Use a hammer to tap dowels in and fasten pieces together. Make sure the dowel is
straight before you hammer.
→Don’t
Use a mallet on the timber dowels as the soft head of the mallet will cause them to
snap.
This product has been designed and made by
Totem Italia exclusively for Plyroom.

ASSEMBLY INSTRUCTIONS
→Assembling the frame
Attach B1, B2 and d to the corresponding square openings of one of
the A pieces. Lock in place by inserting the wooden dowels G. Repeat
with the other A piece. Lower part C onto the frame, taking care to
insert all nodes of B2 into the corresponding openings of C. Insert two
wooden plugs F into both A sides where there is an opening at the top.
PARTS
→Assembling the drawer
For each drawer: Attach 2 x E4 panels to an E2 base as shown and then
attach the front (E1), fixing in place with two wooden dowels F where
there are small holes in the front handles. Attach the E3 back piece
onto E2 as shown. Drawer brackets are provided assembled on both
the drawers and the A frames.
A X 
C X 
D X 
E X  E X 
E X 
E X 
B X 
G X 
Wooden dowels
There will be 2 spare dowels in your box to keep as spares.
B X 
F X 
A
C
B
E
B
D
PRODUCT CARE
For general care we recommend dusting with a clean, dry cloth, or
wiping down with soft cloth wrung dry from plain water (leaving the
surface dry after cleaning). Avoid detergents or solvents of any type.
IMPORTANT!
→Disassembling your frame
This piece is designed to be disassembled when required. Please
note that when disassembling, a hammer must be used to remove the
dowels. ALWAYS hold the hammer in line with the grain of the timber
panel it fastens and use the prongs of the hammer to lever the dowel
out slowly. If this step is not followed it will result in breakage of the
dowel.
Once the timber dowel is removed the mortise and tenon pieces will
come apart with some gentle tapping with a mallet.