PMS MD-3003B1 User manual
MD-3003B1
NOTE
•
If the green light goes out completely or fails to come on or if the unit
is making unfamiliar audio tunes, the unit is unstable and should not be
used until the battery is recharged or replaced.
•
If the unit is not to be used for a certain length of time it is advisable to
remove the battery to avoid battery leakage which could cause serious
damage to the detector.
•
When not in use, the detector should be stored in a dry warm
environment.
SPECIFICATION
OPERATING MANUAL
High Performance Hand Held Scanner
7
Power Voltage
Power
Operating Frequency
Operating Current
Operating Voltage
Operating Temperature
Net Weight
Dimensions
9V Standard or Rechargeable Battery
270mW
22KHz
<50mA
7V-9V
-5C° to +55C°
409G
41(L) X 8.5(W) X 4.5(H)cm
9 10
DETAILS:
1. Detection Face 2. LED(Green /Red Color)
3. AudioAlert 4. Sensitivity Adjuster
5. Handle 6. Battery Lid
7. Low Sensitivity Switch 8. On/Off Switch
9. RechargeableBattery Socket 10. Sound Button
INTRODUCTION
The MD-3003B1 is a high performance Hand Held Metal Detector
designed to meet the exact requirements of the security industry.
Typical uses will include body search for offensive weapons in crowd
control, airport and border security, checking parcels and letters for
metal objects and anywhere that hidden metal needs to be detected.
OPERATION
•
The MD-3003B1 operates on one 9volt standard or rechargeable
battery. To install the battery, slide off the battery cover and place the
battery into its compartment while matching the +/-symbols.
•
Turn the unit on by pushing the on/off switch until it clicks on and the
green LED is lit. The detector is now operational although an increase
in sensitivity and depth range can be achieved by turning the
sensitivity adjuster until the red LED is lit and a constant audio tune is
heard. Turn the sensitivity adjuster (anti-clockwise) until the red LED
just goes out and the tone fades. The detector is now tuned for
optimum sensitivity and depth range.
•
Holding the unit with the detection face towards the surface, sweep
backwards and forwards continuously at a height of 10-30 mm above
the area to be scanned.
•
The presence of metal will be indicated by the audio warning tone and
the red light coming on. If the detector is held still over a metal object
the detection signal will automatically reduce, therefore it is important
that the unit is continually scanning the surface when inuse.
PMS Enterprises
C-125,Ramesh Enclave Kirari
Suleman Nagar,Near Rohini Sec-21
Mobile - 9540305670
PERFORMANCE
The sensitivity of the detector is determined primarily by the size, shape and
composition of the object to be detected.
Typical performance figures are given below :
Maximum Detection Range
Object Low Sensitivity Optimum Sensitivity
38 Caliber hand gun 15cm 20cm
Pen knife 10cm 15cm
Razor blade 5cm 10cm
LOW SENSITIVITY OPERATION
Press the low sensitivity switch during detection, scanner will then only respond to
bigger metal objects such as a hand gun, knife, etc and will not respond to small
metals such as a coin, key, hatpin ,etc. Do not release the low sensitivity switch
until you complete low sensitivity detection.
RECHARGEABLE BATTERY SOCKET
•
Youmay use a 9 volt rechargeable battery to power the detector.
•
It takes four to six hours to fully charge the battery. The battery charger
socket is located at the side of the detector.
Note: Turn off the detector when charging it.
