Pocket home PH-SP3 User manual
PH-SP3
Wireless receiver for control
ofelectric heating devices
- SOCKET MOUNTED -
Control of electric heating systems
The connected electric appliance is switched according
to the required temperature
Two-way radio communication at 433,92 MHz
The control unit PH-BSP is the pilot component
Component of the PocketHome® system
Bedienungsanleitung
Version 11.02
INSTALATION AND ACTIVATION PROCEDURE
PH-SP2 is used for switching the heating device in connectionwith the PH-BSP control unit.
1. Connect receiver in 230V/50 Hz socket
2. The green diode flashes on the receiver; thus the receiver is
ready for further setting.
3. Shortly press the FUNCTION BUTTON (see pic.2) for about
1.5 s (the green and red diode are flashing alternately).
4. On the PH-BSP control unit, press the”Test”
button in the ACTIV mode to activate the SP
switching components (see page 10 of the
PH-BSP instructions).
5. If the code has been learned correctly, the
green and red diodes flash simultaneously.
pic.1
pic.2
GREEN DIODE
(LED1)
RED DIODE
(LED1)
CHILD
SAFETY
FUNCTION
BUTTON
FUNCTION BUTTON:
SHORT PRESSING - coding.
LONG PRESSING (for about 5 s) - RESET
deleting the code from the memory (the green and red
LEDs flash simultaneously).
INDICATION DIODES
LED 1 LED 2 FUNCTION
empty memory, code not learned
code learned
FLASHING ALTERNATELY= code learning mode
FLASHING SIMULTANEOUSLY= code has been
learned
SIMULTANEOUS LONG FLASH= code was ERASED
relay switched
ERROR (if no signal is received from
thetransmitter within approx. 6 hours, it
switches tothe 2-min-ON / 8-min-OFF mode).
LED flashes only if the relay is on, i.e. for 2
minutes.
EXPLANATION: LIT UNLIT FLASHING
TECHNICAL PARAMETERS
Power supply 230 V/ 50 Hz
Communication type two-way
Frequency 433,92 MHz
Sensitivity < - 95 dBm
Range 200 m (in free area), 25 m (in built-up area)
Output relay, max.16A/ 250 VAC
Protection IP40
Working temp. 0 to 40°C
Dimensions(LxBxH) 109 mm x 80 mm x 31mm
DECLARATION OF CONFORMITY
We, ELEKTROBOCK CZ s.r.o., herewith declare that our
product PH-SP3 is in conformity with the basic requirements
and other respective provisions of the directive 1999/5/ES.
Issued: 1.09.2008
CERTIFICATE OF GUARANTEE
(guarantee period for the product amounts to 2 years)
product No.:
examined by::
date of sale::
stamp of shop: ELEKTROBOCK CZ s.r.o.
Blanenská 1763
Kuřim 664 34
Tel./fax: +420 541 230 216
www.elbock.cz
Pb
LEAD FREE
mit Einkland mit RoHS
Send the product for guarantee and after
guarantee service to manufacturer’s address.
