6
• Never blend carbonated ingredients or liquids. The built-up pressure from released gases
will cause the container to burst, resulting in possible injury.
• Avoid contact with moving parts.
• Blades are sharp. Handle carefully when removing the blade, emptying the mixing cup, and
cleaning.
• To avoid injury, never place cutting blades on base without the blender container properly attached.
• Screw on the container bottom firmly. Injury can result if moving blades become exposed.
• Always operate the blender with cover securely fastened.
• Always secure the container by holding it while processing. If the container should turn when the motor
is switched on,” switch “Off” immediately and tighten blender container in the threaded container bottom.
• DO NOT use dishwasher/microwave/sterilizer and other types of cleaning machines to clean the battery
base and motor compartment.
• DO NOT blend hot liquids (more than 40℃/104℉) in the jar. Always allow ingredients to cool below the
boiling point before blending, as blending can cause hot contents to be expelled causing possible injuries.
• DO NOT leave the blender unattended while it is operating.
• DO NOT remove the jar when the appliance is operating.
• DO NOT operate any appliance if the appliance malfunctions or is dropped or damaged in any manner.
• This product has rechargeable Lithium-ion batteries inside. To avoid risk of fire or electric shock or other
injury, DO NOT open the housing or dispose into a fire. There are no serviceable parts inside. Repair
should be done by authorized service personnel only.
• Dispose of the appliance properly by adhering to local material recycling policies.
• Do not fill cup past the MAX line; there needs to be room at the top to blend effectively.
Overfilling might result in ingredients getting stuck or overflowing.
• Make sure the cover on the drinking spout is closed, otherwise when blending ingredients will
splash out.
• Do not expose the portable blender to extreme heat or direct sunlight.
• Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain
minerals that corrode electronic circuits. If your device gets wet, allow it to dry completely.
• Do not use or store the device in dusty, dirty areas. Its moving parts and electronics components
can be damaged.
• Do not store the device in hot areas. High temperature can shorten the life of the electronic
devices, damage batteries, and warp or melt certain plastics.
• Do not store the device in cold areas. When the device returns to its normal temperature,
moisture can form inside the device and damage electronic circuit boards.
• Do not drop, knock, or shake the device. Rough handling can break internal circuit boards.
• Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device.
• Do not paint the device. Paint can clog the moving parts and prevent proper operation.
