Polywood CDD200 User manual

9/14/2012
ASSEMBLY INSTRUCTIONS
CDD200, CDD201, CDD202
Qty. Description
on the arm supports
Step 1
Attach back of arm by threading
frame into the insert nuts
the attached dowel screw into the pilot hole
Model:
4mm Hex Key (included)
until the arm is snug against the back leg.
Step 2
Attach (4)1-3/4 bolts thru the seat
TOOLS NEEDED
ALLHARDWAREISCOATEDSTAINLESSSTEEL
__(1) CHAIR
__(2) ARM ASMB (RH/LH)
__(1) HARDWARE PACK
HDWPK-#8 SCREW PLUGS, 4X (EXTRAS)
1CDD202
CDD201
A -1/4-20 X 1-3/4 WAFER SHCS
4
PILOT HOLE
ROTATE
CLOCKWISE
A
INSERT
NUTS
ROTATE
CLOCKWISE
CDD200

Step 2
Set table upright and tighten all bolts
__(1) Hardware pack
RT348, RCT348, RRT348, RBT348
Models: RT248, RCT248, RRT248, RBT248
Attach the leg assemblies to the table top using
(8) 3" screws.
(4) 3 1/4" Chair bolts.
Step 1
Attach feet to legs using
(4) 3" screws.
Qty. Description
Lay the table top on a flat surface.
4mm HEX KEY: INCLUDED
TOOLS NEEDED
Attach leg braces using
Step 3
__(1) Table top
__(4) Leg
__(2) Foot
__(2) Brace
HARDWARE IS COATED STAINLESS STEEL UNLESS OTHERWISE SPECIFIED 9/19/2012
ASSEMBLY INSTRUCTIONS
4FINE THREAD
B - 1/4-20 X 3-1/4 WAFER SHCS
Removable table plug
included in table
B
12 A - 14 X 3 SOCKET WAFER "B"