Polywood R200 User manual

seat frame with (4) .27x3” screws.
Place seat insert into sideframe
Repeat step 1 on other side
__(1) Head piece
Qty. Description
__(1) Seat insert
Note: front of seat is wider
__(1) Short brace
__(1) Seat frame
Attach rocker bottomwith (4) .27x3" screws
Attach back frame with (2) 2 1/2" bolts
Attach long brace, short brace and
__(1) Long brace
TOOLS NEEDED
Model: R200
__(1) Hardware pack
__(2) Sideframes
__(2) Rocker bottoms
__(1) Back insert
Step 1
Step 2
Place head piece into top of post Step 3
ALLHARDWAREISCOATEDSTAINLESSSTEEL
short brace
B
long brace
A
A
seat frame
back
insert sideframe
B - .27 X 3 SOCKET WAFER A
12
4mm Hex Key, Allen, T-handle
INCLUDED
A - 1/4-20 X 2-1/2 WAFER SHCS
4
head
seat
insert
B
11/21/2012
ASSEMBLY INSTRUCTIONS
B
NOTE: Partialy thread both screws
into post before tightening.
Rocker bottoms may require some
flexing for proper fit.
4mm Hex Key for Drill: INCLUDED

without pilot holes
Qty. Description
Model: TWST, BST
Step 1
__(2) Trays
__(2) Leg assembly
Uses (4) 8x3 screws
8
by resting tray on the leg assemblies
TOOLS NEEDED
A screw gun is required
Phillips head screwdriver
Attach a tray to the middle of the leg assemblies
__(1) Hardware pack
Note:
Trays do not have pilot holes.
Screws go directly into Polywood
ALL HARDWARE IS COATED STAINLESS STEEL 12/4/2012
ASSEMBLY INSTRUCTIONS
A - 8 X 3 PHIL FLAT SCREW
Step 2
Attach other tray to the top of the leg
assemblies.
Uses (4) 8x3 screws