POOLiN EOC05 User manual

Quick Guide
EOC05
It is recommended that beginners to test refer to the Quick Guide first, and any
question please feel free to contact us .
Needle Auto Cutting
Start/Stop

Reminder
Turn off the Power Raise the presser foot for proper threading Reset the handwheel to ensure the
needle in the highest point
123
Environment
Please safe electricity, follow operating procedures, and avoid puncturing needles.
Place the machine in a dry environment and keep it away from children.
Before threading and installing the embroidery frame, please ensure the
machine is in the following state：
The machine supports wide voltage input, the voltage range is 110V to 220V.
Security
Voltage
111

USB
Seam ripper
Shuttle race cover
Wrench
Bobbin cover
Power cable
User manual An envelope
Tweezers Stylus Scissprs
Hoop 100*235 Hoop 100*100
Needles
Bobbin
Pin cap
Screwdriver
Accessories list
Please refer to the teaching video named "Unboxing" in USB.
Tips：
2

Lift the thread stand Insert the thread Insert pin cap
Pass through the hook Pass through the clip Bypass the spring
Bypass the rod Bypass the needles clip Place the thread
Threading the machine
1 2 3
4 5 6
789
Tips： Step 6: Pull the thread upwards, pass through the elastic hook, and pull it.
Step 7: The thread pass through the upper hook.
3

If you use manual threading, follow step
Lower the presser foot Pass the automatic threading
device Press the pressure rod
Pass the barb
Release the pressure bar Pull out thread Through the presser foot
Cut the thread
Threading the machine
b
10 11 12
13 14 15
Through the presser foot,cut the
thread
Pass the pinhole
c
Lower the presser foot
a
bc
a
Please make sure to lift the presser foot before threading.
Tips：
4

Install the bobbin
Pull the buckle to the right Place the bobbin counterclockwise
Follow the arrow to wrap the bobbin thread
Cut off the excess thread
Clamp the cover on the left side
Press the cover
1
2
1
3
2
4
We have prepared a prewound bobbin, which is installed inside the machine.
Tips：
5

Install the embroidery unit
Clamp frame
Loosen the screw
Remove the frame Install backingand fabric
Tighten the screw
Step:Frame connect embroidery unit
Lift the presser foot
Install the frame
Install the frame
Fabric
Backing
1 2 3
4 5 6
1.For better installation, loosen the screws first.
2.Please place a layer of backing under the fabric.
3.Place fabric and backing inside the frame, then
straighten the fabric and tighten the screws.
Tips：
6

Start up
Plug in Press the switch button
2
2
1
1
7

Choose the pattern
Click built-in pattern
1
Choose a pattern
2
8

Config the pattern
Choose the color
Click Config
4
3
Choose the corresponding frame
5
9

Start embroidery
Click trace, confirm embroidery range
Click Emb
7
6
Click ready
8
Put down the presser foot, click the start button on machine
9
10
Start/Stop

After completing the above tests, you can start your own diy embroidery journey.
If you encounter any problems, you can check the user manual or feel free to
contact us at any time.
[e-mail]
POOLIN Sewing Machine
[phone]
POOLIN Users Group
Contact Us