Portable Partitions VP6 User manual

Versare Portable Products 3236 California Street NE Minneapolis, MN 55418
Phone: [phone] Fax: [phone] WWW.portablepartitions.com
VP6 Assembly Instructions
Recommended Tools Step #1 Remove the Partition from the box.
Step #2: There are 4 tubes, two equal
length, one without plastic ends, one with. Step #3: Install the longer tube without
plastic ends to the caster base as shown.
Note the location of the support struts
Step #4 Install screws as shown,
repeat for opposite end. Step #5 Insert one of the two shorter tubes as shown.
•Cordless drill with Phillips
bit (or standard Phillips
screwdriver)
•Adjustable wrench
Support Struts

Versare Portable Products 3236 California Street NE Minneapolis, MN 55418
Phone: [phone] Fax: [phone] WWW.portablepartitions.com
VP6 Assembly Instructions
Step #6: Install screws, and repeat for opposite
side.
Step #8: Install screw as shown, repeat
for opposite side.. Step #9: Install 4 casters to the bottom of the
caster base as shown, tighten with wench.
Step #10: Drape over partition panel,
tension and hold in place with
Velcro.
Step #7: Add tube with plastic ends to the two
standing tubes as shown.
Step #11: Install support struts as
shown above, repeat for opposite side.