POSline TPC7030 User manual

KEYPADS
It may take up to 2 hours to fully charge the empty backup battery.
The first time charge should be for at least 16 hours to insure a
proper charge
 After you have initially charged your device for about 8 hours, the
device is ready to be used.
TPC7030Portable Data Collector
Quick Start Guide

Front View Back View
Connector
Screen
Scan Button
Reset Button
Battery Door Latch
Scan Window
Buzze r

TPC7030 Quick Start Guide
1
2
3
5
6
1. Scan key
2. Cursor key
3. 10-key pad
4. Enter key
Battery Cover
http://www.posline.com.mx See User Manual for more information
5. Power key
6. ESC key
7. Reset
SFT key
Switches between the character input mode and the number input mode.
[abc][ABC] lit on the LCD screen indicates the character input mode.
When [123] is lit, the terminal is in the number input mode.
Function key
F1 (-): Inputs the minus (-) sign
F2 (SP): Inputs a space
F3 (DEL): Deletes a character
F4 (BL): Turns the key lights ON and OFF
F5 ( ): Increases buzzer volume
F6 ( ): Increases LCD backlight
P1: Decreases Buzzer volume and program 1 (for user SDK define)
P2: Decrease LCD backlight and program 2 (for user SDK define)
4
Charging the Main Batteries at least 16 hours for the first time
7

KEYPADS
Red = Normal charge / Green = Full Charge












                   
Support Information
More Information on the TPC7030
Visit the POSline® Web site http:// www.posline.com.mx
Setting up, Using and troubleshooting the TPC7030
TPC7030 User’s Manual
Available at http:// www.posline.com.mx
49-P20001-001 Rev. A – November 2008

Single slot Serial / USB Cradle
Spare Battery
Charge LED
Press mobile computer
firmly into cradle
1. Turn the screw
2. Open the cover


Be sure to turn the terminal off before you do this
TPC7030 Quick Start Guide
The TPC7030 portable data collector let you link to a
host computer through the CRD-20 cradle for data
communication.
Install or replace the main battery in the terminal
Install or replace the main battery in the gun grip
1. Slide the main battery compartment cover lock to
the FREE position and remove the cover
2. Load a Li-Polymer battery pack into the main battery
compartment in the direction shown in the figure
3. Attach the battery compartment cover to the
terminal and slide the main battery
compartment cover lock to the LOCK position.
Charge LED