PotteryBarn Weeping Witches Willow Tree User manual

Weeping Witches Willow Tree
IMPORTANT SAFETY INSTRUCTIONS
WHEN USING ELECTRICAL PRODUCTS, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWEDINCLUDING
THE FOLLOWING:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Reference the National Electrical Code, ANSI/NFPA70, specifically for the installation of wiring and clearances from
power and lighting conductors.
Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicablecodes and
standards, including fire-rated construction.
Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use.When products are used in
outdoor applications, connect the product to a Ground Fault Circuit Interrupting (GFCI) outlet. If one is not provided,
contact a qualified electrician for properinstallation.
This seasonal use product is not intended for permanent installation oruse.
Do not mount or place near gas orelectric heaters, fireplace,candles orothersimilarsources of heat.
Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
Do not let light bulbs rest onthesupply cord oron any wire.
Do not electricallyconnect this product to any other product by cutting or joining the products together.
Unplug the product when leaving the house, when retiring for the night, or if left unattended.
This is an electric product-not a toy! To avoid risk of fire, burns, personal injury and electric shock it should not be played
with orplaced wheresmall childrencan reach it.
Do not use this product for other than its intended use.
Do not hang ornaments orotherobjects from cord, wire, orlightstring.
Do not close doors orwindows on the product or extension cords as this may damage the wire insulation.
Do not cover theproduct withcloth, paper orany material not part of theproduct when in use.
Do not install oruse within10 feet of a pool.
Do not use in a bathroom.
LEDs are not replaceable, DO not twist thebulbs.
Do not use ifthe insulation ofthe light set or cable is damaged.
Only use 3V / 1.0A output adapter provided.
Read and followall instructions that are onthe product or provided withthe product.
SAVE THESE INSTRUCTIONS
Placement Instructions:
The product is meant for INDOOR use or OUTDOOR where covered patios and covered porches that are fully
protected from water, even duringstorms.
Do not position orplace nearheaters or any other direct sources of heat.
Always position electrical wire so as notto cause a tripping hazard to the elderly, pets andchildren.
Do not position this product whereit may becomecovered by other items e.g. curtains, nets orbedding.
Do not position the product in a manner that can cut or damage wire insulation.


Determine the desired location for this product, MAKE SURE THATA POWER OUTLET IS REACHABLE BY THE
ELECTRICALWIRES without straining the wires.
Thisproduct uses long-lasting, non-replaceable LED bulbs; there are total 32 LEDs on 24”H small tree, 72LEDs on
the 48”H large tree.
Use and Care Instructions
Remove all parts and hardware from box along with any plastic protective packaging, taking care not to damage or twist
the wires while unpacking.
Before using orreusing, inspect product carefully. Discard any products that have cut, damaged or frayed wire
insulation or cords, cracks in thesockets or enclosures, looseconnections, or exposedcopper wire.
Whenstoring the product, carefully remove the product from wherever it is placed, including tree, branches, orbushes,
to avoid any unduestrain or stress on the product conductors,connections, and wires.
When not in use, store neatly in acool, dry location protected from sunlight.
Wipe clean with a soft, dry cloth or static duster. Do not usesolvents or abrasive cleaners.
WARNING:
Rise of Electric Shock. When used outdoors, install only to a covered Class AGFCI protected receptacle that is
weatherproof with the powerunitconnected to the receptacle. If one is not provided, contact a qualified electrician for
proper installation. Ensure that the power unit andcord do not interfere withcompletely closing the receptacle cover.
Rise of Electric Shock. Mount the unit at aheight greaterthan 1 foot from thegroundsurface.
Assembly Instruction:
Remove all parts and hardware from box alongwith any plastic protective packaging, taking care not to damageor
twist the wires while unpacking & during assembling. Check the product before use for loose or damaged wiring and
that all the bulbs are secure.
Tighten the trunk onto the base, and then bend the branches upward tomake the tree at your favorite.
Correctly insert the connector at the end ofthe electrical cord of product into the supplied
Transformer/adapter until secure. Plug the transformer/adapterintothe proper electrical
outlet andtestthe product. Input:AC120 60 Hz 0.5AMax, Output: 3V –1.0
SAVE THESE INSTRUCTIONS –Thismanual contains important safety and operating instructions for power units.
SKU# 2552136 & 9958513
Made in China Thank you for your purchase
Stores | Catalog | www.potterybarn.com
USA 1.888.779.5176
Step 1
If place the tree in outdoor, please use the metal stick
provided to make the tree stand on the ground securely
Step 2