PotteryBarn DARCY FOUNTAIN User manual

P O T TE R Y B A R N
DARCY FOUNTAIN
ASSEMBLYINSTRUCTIONS
CAUTION:
This Pump Has Been Evaluated for UseWith Water Only.
Important Safety Instructions:
These instructions are provided for yoursafety. It is very important that you readcarefully before
beginning the assembly and installation ofthis water fixture.
This product must be installed in accordance with the applicable installations codes by the person
familiar with the constructions and operation of the product.
The water fixture ismeant for outdooruse.
For yoursafety, it is strongly recommended that two people install the water fixture.
Save these instructions.
WARNING:
This pump is supplied with a grounding conductor and grounding-type attachment plug. To
reduce the risk of electric shock, be certain that it is connected only to a properly grounded,
grounding-type receptacle.
To reduce risk of electrical shock or personal injury. Do not plug the submersible pump without
water.
PARTS INCLUDED:
(A) BASE (1)
(B) BASIN (1)
(C) TOP TIER (1)
(D) ALUMINUM TUBE (1)
(E) FLEXIBLE HOSE (1)
(F) PVC PIPE (1)
ACCESORIES INCLUDED:
(G) SUBMERSIBLEWATERPUMP (1)

Assembly Instructions:
To replace the submersible pump, please followthesesteps:
1. Unplug the water pump to powersupply.
2. Remove any existing wateronthe basin ofthe fountain.
3. Lift thetop tier (C) and detach the flexible hose from thesubmersible pump.
4. Pull out the wire power cord ofsubmersible pump from the basin ofthe fountain.
5. Insert newsubmersible water pump into the basin, then connect the flexible hose into the water
pump.
Care Instructions:
Handle with extracare.
Wipe with clean wet rag.
Thank you for your purchase
Store | Catalogue | www.potterybarn.com
USA 1.888.779.5176
1. Put the base of the fountain (A) and place the basin of the fountain (B)
at the top part ofthe base ofthe fountain (A), twist clockwise to lock.
2. Put the submersible pump (G) inside the basin (B) of the fountain. Then
insert its electrical wire into the hole ofthe pipe (F) that is on the inner part of
the basin (B) of the fountain. Thread the electrical wire through the body of
Base (A) and let the plug out ofthe bottom of Base (A).
3. Put the top tier (C) of the fountain and connect the flexible hose (E) to the
spout of the submersible pump (G). Make sure the flexible base (E) is
connected tightly to the submersible pump (G) then place the top tier (C)
on the basin (B) ofthe fountain.
4. Put 4 litres of water insidethe basin (B) of the fountain then Plug the male
plug into the outlet.