PowerAcoustik PT-104CM User manual

| Owner’s Manual | Manual
HIGH PERFORMANCE
10.4 INCH DIGITAL LCD CEILING
MOUNT MONITOR
PT-104CM
а
Power вен

Owner’s manual
1. PRECAUTIONS
1.
2.
Om WwW
Operate the transmitter on 12V DC supply only.
Do not open the monitor.
Opening or removing covers may expose you to dangerous
shock hazards or the risks.
Warranty will be void.
. Do not expose temperature extremes or direct sunlight.
. Avoid dropping and hard impact.
. The driver should not watch while driving vehicle.
. Do not spill and liquid into the cabinet or use your monitor
near water.
. Do not place this product on a slopping or unstable surface.
As the monitor may fall, causing serious damage to the
monitor.
. Do not Scratch or press the surface of the LCD panel, it will
cause a permanent damage.
Use only soft cloth with non-ammonia glass cleaner to clean
the panel.

| Рт-тодсм Й
2. MONITOR PARTS |
Slide Monitor
z ~~ Release Button
)
C»
=
Л»
Sensor —+ od Ex Power
Menu —4 А Сотго! Ор
Select Down Control Down
or AV1, AV2, AV3
. FEATURES
* On screen Display
* Composite Video Input
* Resolution 800 х 640
e NTSC/PAL Switchable
e Multi Function Remote Control
• 12V DC Power Input
* Built-in IR Transmitter
e FM Transmitter for Audio Signal 87.5~89.5
* Flip-down Angle(0-115 Degrees)
* Swivel 15°, 30° (Left, Right)
* Triple A/V Input
* Built-in 2 Dome Lights

Омпегз manual |
4. REMOTE CONTROL
VOLUME
CHANNEL: | | —-(CONTROD
(SELECT) p
UP/DOWN UP/DOWN
MENU
DISPLAY - SOURCE
FUNCTION MEMORY
SOUND Q.VIEW
REMOTE CONTROL OPERATION
Power- Power On/Off button.
Mute- Sound On/Off
Menu- Show OSD Menu on the screen Menu selection
Channel
Up(A)
|
Channel
Down,
v).
7410001
up
and
down.
Volume Up(A)
Volume control.
Volume mM,
Source - Selection button for Selecting AV1, AV2, AV3
signal source.
>

5. INSTALLATION GUIDE
1. Using self-tapping screws to attach mounting plate to
selected position.
2. Install on to the mounting plate using screws supplied.

Owner’s manual
6. EXPLANATIONS OF MENU
IMAGE MENU
IMAGE
MENU
ЗЕ
MERS
|
BRIGHT
50
*
Brightness:
Controls
the
brightness
CONTRAST 52 ын LCD, use A or ¥ to adjust the
SATURATION ar * Contrast: Controls the contrast of the
LCD, use A or V to adjust the setting.
UO BANSEGAM * Saturation(color): Control the
TSC ECA Saturation of the LCD, use A or V to
EXIT adjustthe setting.
SELECTA Y CONTROL 4» * Hue(tint): Use A or V button the
emphasis on setting one of Red, Green
or Blue color.
HUE 51
INPUT AV1, AV2, AV3
SOUND MENU
SOUND MENU
VOLUME 23
TREBLE 23
BASS 43
BALANCE 0
FM Sound FM 87.5-89.5
EXIT
SELECTA Y CONTROL 4»

| Рт-тодсм _
7. SPECIFICATIONS
POWER SUPPLY DC 12VOLT + 10%
CURRENT CONSUMPTION 750тА
VIDEO FORM NTSC/PAL/SECAM
SPEAKER OUTPUT(BUILT-IN) 1W (R.M.S)
VIDEO
INPUT
LEVEL
1Ур-р,
750
ACTUAL SCREEN SIZE (mm) | 211.2(W)X158.4(H)
DIMENSION (mm) 273(W)X299(H)X35(D)
WEIGHT 1.4Kg
8. TROUBLESHOOTING GUIDE |
Remote control unit doesn’ t work
* Batteries are missing, dead or incorrect polarity
= Replace batteries
* Remote control distance is too far
= The distance must be less than 5m
* Improper direction of remote control
= Point the remote control unit to the sensor
No picture and sound
* A/V source connection is wrong
= Check the A/V source power
No color
* Incorrect setting of playback system
-) Select to correct position of MENU NTSC/PAL/SECAM

Important Safety Instructions
* Please read through the "Owner's Manual" and "Setup Manual” to use the product
properly and safely before it is operated. Installing this product in a place that is
your driving your own car may cause an accident, fire, electric shock, or damage to it.
№ САЦТОМ exposed to damp, wetness, steam, dust, or oily smoke, or where it can interfere with
* Avoid «Branch Registration, Volume Control» «TV Viewing, Radio Listening» durin
/N WARNING 9 S g> auring
* Travel your own car in accordance with the real traffic regulation if the navigation
System guides a route.
driving.
AV System
1. AV System is equipped with the protective circuit for safety during driving so that the driver cannot view
TV or listen to radio. Be sure to connect the appropriate terminal of the main unit to the parking brake on
the vehicle or attach parking sensor.
Looking at the display screen or performing complex manipulation to ensure safe driving may cause a
traffic accident due to carelessness in the forward direction. When operating this system, the driver
should pull up his own car in a safe place and then operate the system. There are some features which
cannot be controlled during travelling.
Installation
єр There are some types of vehicle on which such equipment as main unit, option unit, antenna, and setup
card cannot be installed. For details, contact the dealer from whom you purchased your system.
Wiring for the installation of such equipment should be provided praperly in a place that does not interfere
with driving or safety device such as airbags.
Wire the equipment properly according to “Setup Manual” supplied with the product. Otherwise,
malfunction or damage may result. Warranty does not apply to such damage. If it is difficult to connect or
install the equipment, contact your dealer. We do not take any responsibility for any damage caused by
change or modification of the equipment.
Use power source for vehicle with fuse having power capacity for the system, heal resistance and
weather resistance in compliance with "Owner's Manual" when connecting the equipment to the power
source on the vehicle. Using power cable lor other than vehicle may cause damage to the system.
All the equipment has been designed to use 12V battery power source for vehicle. The equipment should
not be connected to 24V power source on recreational vehicles and trucks.
Customer Service Instructions
Please, Note Warranty card.
Power сле