Clean the exterior parts of the appliance thoroughly with a damp cloth. DO NOT use metal
scouring pads.
Ensure that the appliance is completely dry before use and that the Crumb Tray is fitted
into position.
Place and use the appliance upright on a horizontal, stable, dry and heat-resistant surface.
Damage to the appliance may occur if it is placed on an incline or decline.
(First use)
Ensure that the“Start Control Lever” is in its uppermost position, switch the appliance on,
and pull the “Start Control Lever” down. Turn the “Rotary Knob”to the hottest level of“6”.
The appliance starts immediately and stops automatically with the“Start Control Lever”
returning to its original position. This process burns off any accumulated oil or dirt from
the manufacturing process, and any odour given off is normal.
(Subsequent uses)
Ensure that the“Start Control Lever” is in its uppermost position, switch the appliance on,
place the bread in the“Bread Insert Slot”, and pull the “Start Control Lever” down. Turn the
“Rotary Knob”to the desired level of toasting. The appliance starts immediately and stops
automatically with the “Start Control Lever” returning to its original position. Switch off the
electric mains and unplug the power cable before removing the toasted bread. Pushing
the “Cancel”Button will stop the heating and will return the“Start Control Lever” to its
original position. (refer to the section “How to Use”for additional steps)
Never place the following items in the appliance during heating as they may create a fire
or risk of electric shock:
• oversized foods or metal utensils must NOT be inserted into the appliance;
• containers constructed of any materials (including but not limited to: cardboard, plastic,
paper, metal foil, etc.);
• bread spread with butter, margarine, jam, peanut butter, kaya, oil, grease, etc.
Always use tongs when inserting or removing bread from the hot toaster. Beware that the
area round the Bread Insert Slot will get hot during use.
cover the appliance during functioning;
insert objects or body parts inside the protection cover of the appliance;
attempt to dislodge food when toaster is plugged in;
use any of the following agents as a cleaner: gasoline, thinners, or benzene;
toast bread without removing the wrappers (including plastic, paper or metal) first;
operate the appliance for more than 30 minutes without turning it off for at least 10
minutes to let the appliance cool down for a total usage of 2 hours a day – failure to heed
this warning may result in motor failure.
12.
13.
14.
15.
DO NOT touch the outside and especially the inside of the toaster while it is operating. This is
to prevent scalding. The bottom of the toaster becomes exceedingly hot as the toaster
operates. Only touch the “Start Control Lever”, “Cancel”, “Reheat” & “Defrost” Buttons or the
“Rotary Knob”.
Avoid placing the power cable on abrasive or sharp surfaces or in positions where it can be
damaged easily. The cable must NOT be placed under carpets, or covered with throw rugs,
runners or similar. Arrange the cable away from the high traffic area, and where it will NOT be
tripped over. DO NOT allow the cable to hang above the Bread Insert Slot, or near hotplates,
hobs and burners.
DO NOT use or store the appliance outdoors. Store and use the appliance only indoors, or in
any case, protected from weathering such as rain, direct radiation of the sun and dust.
Operation
If you are using the appliance for the first time, you should:
a.
b.
c.
d.
e.
f.
g.
Make sure to remove any label or protective sheet which may prevent its proper
functioning.
DO NOT:
•
•
•
•
•
•
3
