■
■■■
KEY FUNCTIONS
Mode: With this button you can switch between the different modes.
Up: During normal operation, this key allows you to switch between the 12 and 24 hour display.
In the settings menu you may increase the time value by pressing this button, to increase the value
faster hold the button a little longer.
Total: Display consumption costs between week, month and year.
In the settings menu the value can be lowered with this key,press and hold the button a little longer
to speed it up.
Set: A short press to enter the date settings.You confirm the inputs by briefly pressing the SET
button.A long press to get into the tariff and CO2 settings.You confirm the entries by briefly
pressing the SET button.
RESET: Press and hold the RESET button with a pointed object to clear all settings and restart the
device.
Date /Time Settings:
Note: Werecommend the device for about 2-3 hours before startup into a properly plugged power
outlet to the internal Charge the battery.
Briefly press the "SET" button to enter the setting mode. If the value to be set starts to flash. To
adjust the respective value, press the "UP" key or the "TOTAL'.'key until the desired value is shown
in the display. By a short press on the "SET" key confirm your entry and move on to the next
position.
The adjustment order is as follows: Year-> Format of the date (month/ day or day/ month) >
Month > Day > Hour > Minute
Note: If no action is taken within 30 seconds, he device automatically switches off the setting mode.
Cost settings: You have the option of two different electricity cost tariffs for different
set time periods. If price 1 and price 2 are set to "O.oo·;the cost function is switched off.
Normally it is sufficient to set only tariff 1 (price 1). Price 1 is the basic rate.
If this is not set, entry for price 2 is not possible.
Press and hold the "SET" button for about 2 seconds to enter the setting mode to start for the cost.
The currency unit will now flash in the display.
Use the "UP" or "TOTAL'.'buttons to set the desired currency.
Confirm your entry with the "SET" key.
After the display "Price 1"flashes. Press the "SET" button again. The Days of the week start to flash.
Use the buttons "UP" and "TOTAL'.'the desired period for which the first tariff (price 1) should apply.
After you have set the days of the week, confirm with the "SET" button.You can then change the
hour display for the beginning of the set billing period. Confirm the entry with the "SET" button and
repeat the process with the minute display.To confirm Again with "SET:
After that, set the costs. The first digit of the cost display begins to flash. Set these with the buttons
"UP" and "TOTAL'.'and confirm with "SET':Then repeat this with the second and third digits.
Confirm each setting with the "SET" button.
