PowerTek PowerBeam ACD039 User manual

Model No. ACD039
Power Beam
20MCP Searchlight with 12 LED Area Light
and Vehicle Jump Starter
Instruction Manual
Sheet 1 of 8
MobilePower, LLC. Bluffton, SC 29910
www.mobilepower-us.com
Customer Support: [phone]
[email protected]

Model No. ACD039
Sheet 2 of 8

Model No. ACD039
IMPORTANT ADVISORY NOTES
• Thespotlightbecomesveryhotduringuse.DONOTtouchlensorblocklensareaduringoperation.
• Lightbeamisextremelypowerful.DONOTshinedirectlyintoeyes.
• Unitisnotwaterproof.DONOTuseSpotlightunderwaterorimmerseinwater.
• Donotusewithdrycellbatteries.Thesebatteriesmayburstandcauseinjurytopersonordamage
 personalproperty.
• Donotattempttofacethebatterybeingjumped.Stayawayasfar
 aspossiblefromthebatterywhenmakingthenalconnection.
• DONOTCONNECTTOorjumpstarta6or24Voltbattery.
 Ifbatteryacidcomesincontactwithskinoreyes,rinseimmediatelywithwaterfor20minutes.Seek
 medicalattentionifredness,irritationorpainispresent.
• DONOTsmoke,usematches,lightersoranopenamenearbatteries.
• Thisproductcontainschemicalsubstancesincludinglead.Washhandsthoroughlyafterhandling
 LeadAcidBatteries.
• Never allow red (Positive) and black (Negative) clamps to   come in contact with each other or
 contactwithmetalobjectatthesametime.
• Toprotectagainstelectricalhazards,donotimmersecharger,adaptersorunitinwaterorother
 liquid.
• Closesupervisionisnecessarywhenworkingnearchildren.
• Donotuseunitforapplicationsotherthanitsintendeduses.
• Alwaysconnectthered(+)clamptothepositivebatteryterminalrst.Connectblack(-)clamptothe
 vehicleengineblock,orametalpartofthevehiclewhichisconnectedtothevehiclemainground
 systemasnalconnection.
• Jumpstartvehiclesinawell-ventilatedareaonly.
• Donotexposetheunittomoistureoruseitinexceptionallyhotonditions.
• Wearcompleteeyeandclothingprotection.Donottoucheyeswhileworkingnearbattery
• Donotattempttoremoveorreplacethebatteryusedinthisdevice.Whenthebatteryhasreached
 theendofitsusefullifetime,taketheentireunittoabatteryrecyclingfacility.
• Remove metal and personal jewelry such as:rings,  bracelets, necklaces and watches, while
 workingwith a lead acid battery.Thiscanproduceashort-circuitthatmaycause severe burns.
 Neverchargeorjump-startafrozenbattery.
• Donotoperatethisdevicewhilewearingvinylclothing.
 Staticelectricitymaybegeneratedwhenvinylclothingisrubbed.
• Thisproductisnotintendedforuseintherainortemperaturesabove150ºF.
• Useonlytheprovidedchargers,cablesandclamps.Unauthorizedpartsmaydamagetheunit.
 Thisproducthasnoconsumerserviceablepartsexceptthereplaceablefuses.
• Keepoutofthereachofchildren.
• Keepbatteryterminalsclean.Becarefultokeepcorrosionfromcomingincontactwitheyes.
• Donotletthecordsoftheunitorjumperclampsgetwet.
Sheet 3 of 8

Model No. ACD039
• UseofDAMAGEDorIMPROPERextensioncordstochargethisunitcouldresultinriskofreand/
 orelectricshock.Makecertainthattheextensioncordisinsafeandingoodelectricalcondition.
• Preventwaterfromenteringintotheunithousing.Waterwilldamagetheinternalelectronicsboard.
• Thisunithasabuilt-inleadacidbattery.Althoughthisunitarrivespartiallychargedfromthefactory,
 itMUSTbefullychargedbeforetherstuse.
• Rechargetheunitaftereachuseorevery3monthstopreventthebatteryvoltagefromdepleting.
ADJUSTABLE HEAD
To adjust headangle, gently pullup on rimat bottom. Angle can beadjusted to 4differentpositions
indicatedbya “click” sound. Donotforcehead beyond nalpoint.Returnhead to closedpositionfor
storagetopreventdamagetomechanism.
SPOTLIGHT
To operatethe spotlight pressthe switchon handle ofyour PowerBeamto either the“High” or“Low”
position.
Theoperationtimeisuptoapproximately35minutes.
Presstheswitchto“O”toturnoffthespotlight.
LED AREA LIGHT
YourPowerBeamisequippedwithbrightLEDlightslocatedin
therim.Theseprovideanarealightforworkingandgeneralillumination.Tooperate,presstheswitch
locatedonthebackoftheunittothe“LEDAreaLight”position.
Thearealightwilloperatecontinuouslyformanyhoursonafullcharge.Presstheswitchtothemiddle
positiontoturnofftheLEDlights.
RED LED EMERGENCY FLASHER
Your Power Beam is also equipped with RED LED emergency ashers. To operate, press the switch
locatedonthebackoftheunittothe“REDLEDEMERGENCYFLASHER”position.
USB POWER PORTS:
Your Power Beam is equipped with THREE 5 volt 2100mAh USB ports for powering or charging
variousdevicesincludingmobilephones,MP3players,tablets,e-Readers,notebookcomputersandother
equipmentwithUSBcapability.Tooperate,connecttheUSBcablethatwassuppliedwiththedeviceyou
wanttochargetooneoftheUSBports.Pressthebuttonlabeled“USB”oncetoturnon,pressagainto
turnoffwhennished.
Sheet4of8

Model No. ACD039
VEHICLE JUMP START INSTRUCTIONS:
WARNINGS:
Reviewyourvehicleowner’smanualinstructionsbeforeattemptingtojumpstartyourvehicle.Failureto
followtheseadvisoryinstructionsmayresultinpersonalinjuryandpropertydamage.Usesafetyglasses
toprotectyoureyeswhileworkingnearabatteryduringvehiclejump-starting.Jumpstartavehicle
inanopenareawithoutanytypeofobstructions.
1. Turnoffthevehicleignitionandallaccessories(Suchasradios,lights,andairconditioners,etc).
2. Applytheemergencybrakeandputthosevehicleswithautomatictransmissioninparkposition.
3. Determinethepolarityofthevehiclebatteryterminals.Thepositive(+)batteryterminalnormallyis
 largerindiameterthanthenegative(-)terminal.Ifyouareunsure,youmustrefertothevehicle
 owner’smanual.
1. Determine whether your vehicle is equipped with a negative or positive grounded system: Most
 vehiclesusethistypeofsystem.PositiveGroundedbatteryterminalisgroundedtochassisoranyother
 part of the vehicle. If you are not certain of this important information, YOU SHOULD REFER
TO YOUR VEHICLE OWNER’S MANUAL.
2. Remove clamps from the holders. Never allow clamps (positive  & negative terminals) to touch
 togetherorcontactthesamepieceofmetaltopreventshort-circuits.
3. Followtheinstructionsforanegativegroundedsystemorpositivegroundedsystemasindicated
 below:
Negative Grounded System
Connect the RED CLAMP (positive +) to the positive  terminal of the vehicle battery or the remote
positiveterminalifavailable.
ConnecttheBLACKCLAMP(negative-)tothevehicleengineblock,orametalpartofthevehiclewhich
isconnectedtothevehiclemaingroundsystem.Donotclampdirectlytonegativebatteryterminal,main
fueldistributionmoduleorsheetmetalparts.
ThePolarityProtectionSystemGREENLEDisilluminatediftheproperconnectionshavebeenmade.
WARNING: If RED LED is illuminated, DISCONNECT the booster clamps from battery terminals.
Reconnecttheboosterclampsbyreversingtheconnectionstotheproperbatterypolarity.
Sheet5of8

Model No. ACD039
Positive Grounded System:
ConnecttheBLACKCLAMP(negative-)tothenegativeterminalofthevehiclebattery.
ConnecttheREDCLAMP(positive+)tothevehicleengineblock,orametalpartofthevehiclewhich
isconnectedtothevehiclegroundsystem.Donotclampdirectlytopositivebatteryterminal,mainfuel
distributionmoduleorsheetmetalparts.
ThePolarityProtectionSystemGREENLEDisilluminatediftheproperconnectionshavebeenmade.
WARNING: If RED LED is illuminated, STOP and disconnect the booster clamps from battery
terminals. Reconnect the booster clamps by reversing the connections to the proper battery
polarity.
1. TurnontheMainPowerBoosterClampsSwitchbyrotatingtheswitchtotheONposition.
2. Allow3to5minutesofchargetime.Itishighlyrecommendedhavingasecondpersontoassist
 holdingtheunitsecurelyinplaceduringthenextsteps.
3. StarttheengineandStopifthevehicledoesnotstartafter2to3secondsofenginecranking.Wait
 2to3minutesthentryagain.Repeattheabovestepsseveraltimesuntilthevehiclestarts.
4. Ifthevehiclestarts,turnofftheMainPowerSwitchbyturningtheswitchtotheOFFposition.
5. Disconnecttheclampsasfarawayfromthevehiclebatteryaspossible.
6. ForNegativeGroundedSystem,disconnecttheBLACKCLAMPNegativerstandthentheRED
 CLAMPPositive.ForPositiveGroundedSystem,disconnecttheREDCLAMPPositiverst,and
 thentheBLACKCLAMPNegative.
7. Stowtheboosterclampsintotheirstoragecompartment.
CHARGING INSTRUCTIONS:
USE CAUTION:
Priortochargingthisdevicereadalltherelatedinstructionsindicatedbelow.Thisproductmayarrive
partiallychargedfromthefactory.Itishighlyrecommendedtofullychargetheunitafterpurchaseand
beforeinitialuse:
• MakecertainthatthePowerSwitchissettotheoffposition.
• Do not charge near ammable material, open ames or any location which may accumulate
 ammablefumes.
• Makecertainthatanyelectricaloutletusedtochargethisdevicethatislocatedinapotentiallywet
 ormoistareaisprotectedbyaGroundFaultCircuitInterrupter(GFCI).
• Makesurethatbothboosterclampsaresecurelyplacedintheirdesignatedstoragecompartments
 whennotinuseandduringthechargingperiod.
Sheet6of8

Model No. ACD039
A. AC Charging At Home with 110 Volt Charger
1. KeepthePowerSwitchinmiddle“O”offpositionwhilecharging.
2. Insert the AC charger round plug into the Spotlight Charging Port  located at the back of the
 spotlight.
3. Connectthe110VoltACChargerintothe110VoltAChomereceptacle.
4. Fullychargethespotlightaccordingtothefollowingchargingschedule:
 Firsttimecharge:.....................................................24hours
 Rechargeandsubsequentcharge:.......................18hours
5. Unplug the AC charger from the 110 Volt receptacle rst and then remove theround plug
 fromtheSpotlightChargingPort.
B. DC Charging In Your Vehicle with 12 Volt Charger
1. KeepthePowerSwitchinmiddle“O”offpositionwhilecharging.
2. Insertthe12VoltDCChargerroundPlugintotheSpotlight
3. ChargingPortlocatedatthebackofthespotlight.
4. Connectthe12VoltDCChargerPlugintothevehiclecigarettelighteror12Voltaccessoryport.
5. FullychargetheSpotlightinternalbatteryfor8hourswhilethevehicleengineisrunning.
6. UnplugtheDCchargerfromthevehiclecigarettelighteror12Voltaccessoryportrstandthenremovethe
 roundplugfromtheSpotlightChargingPort.
12 VOLT DC CHARGER ADAPTOR FUSE REPLACEMENT:
1. Unscrewtheretainerringatthetipofthe12VoltDCchargerplug.
2. Replacetheinternalglassfusewiththesamegradefuseratedat2-AMP.
SPECIFICATIONS:
600Peakcrankingamps 300continuouscrankingamps
Batteryratedcapacity 12Volt-8Ah
Bulb H4-120WattQuartzHalogenBulb
LEDarealight 360mA
Sheet 7 of 8

Model No. ACD039Model No. ACD039
Sheet 8 of 8