Premier Clean Monarch 250 User manual

Ducted Vacuum
Owner’s Manual
User instruction manual and warranty information.
Please read this before installing or using your
Premier Clean Ducted Vacuum Unit.
For replacement bags or filters find your local dealer -
1
www.premierclean.com.au

2
Information
For an up to date look at Premier Clean
Ducted Vacuum Accessories -
Find your nearest dealer at www.premierclean.com.au
www.premierclean.com.au
Monarch Series
Bag Units
Premier Series
Bag or Bagless
Units
Premier Series
3000, 4000,
5000 and 6000
Bag or Bagless
Units
Compact Series
Bag Unit
Typhoon Mini
200 Bag Unit

3
Table of Contents
Installation 4
Unit Installation
Muffler Installation
To change Premier 3000, 4000,
5000 and 6000 from Bagless
to Bag System
Operating Instructions
Operation & Care 5
Accessories 6
Speed Variation Hose 7
Maintenance 8
Motor
Changing bags and filters
Troubleshooting 9
Decreased Suction
Vacuum will not start up
Vacuum will not stop
Warranty Information 10
Warranty & Warranty Requirements
www.premierclean.com.au

4
Using the mounting plate provided with your Vacuum System, secure the
mounting plate to the wall at a height allowing easy access for maintenance of
the filter, dirt receptacle and or bags.
Please note: Monarch Systems must be at least 10 to 15 cm off the ground.
Contrary to all other connections in the ducting of your vacuum system, do not
glue the last fitting going into your unit. This will allow easy removal for any
repairs.
Attach your low voltage wires to the low voltage inlet on the side of your unit.
Simply strip the wires approx 1/2 cm and clamp them into the plugs supplied.
Plug the power cord into the 240 Volt power point and you are ready to start
cleaning.
Muffler Installation
Monarch 490, 550 and 850 and Premier 490, 550, 4000, 5000 and 6000
are supplied with a exhaust muffler. These simply fit on to the side of your unit
with the elbow supplied. Place the elbow onto the exhaust of the motor, it’s best
to tape the elbow to the muffler.
How to change from a Bagless System to a Bag System
Premier 3000, 4000, 5000 and 6000 units come Standard as a Bagless
System. These units can be used as a bag system.
• Remove weighted filter - leaving in secondary filter
• Attach the 45 degree bend to the pipe inside the unit
• Glue or tape bag adaptor to the 45 degree bend
• Push bag over the top of the adaptor
• Replace bottom bin
• Unit is now ready to be used as a Bag System
Installation

5
Operation & Care
STARTING VACUUM – Simply open outlet cover, insert hose and system will
automatically start. To stop, remove hose and allow suction to reduce before
closing the inlet.
If you have chosen a switch on/off handle hose plug the hose into the inlet with
arrow facing up, use handle on/off switch to operate.
Operating Garage Point. Open inlet cover and insert hose. Turn the switch on
the side of the system to the ON position. When finished turn switch off and
remove hose.
TIPS TO CARE FOR YOUR DUCTED VACUUM SYSTEM – Your system’s
unit is warranted against defective materials and workmanship but not against
misuse. There is a service charge for repairing or replacing damaged or
misused components of the system and for service calls. To ensure your ducted
system is a life-time improvement for you and your family. Follow these simple
tips and you will enjoy it for many years.
1. Do not place any articles around the motor of the power unit.
To do so could cause the motor to overheat as it will impair the cooling of the motor.
2. Use one inlet at a time to maintain proper air flow.
To use more than one vacuum inlet at a time will reduce the air flow that is
required to effectively clean the carpets.
3. Hold inlet door open when removing hose.
After removing the hose from the inlet, hold the inlet door open for a few
seconds to make sure the unit has stopped and to clear any residual dirt out of
the ducting.
4. Do not pick up liquids.
Do not vacuum liquids into the vacuum ducting as any liquid left in the ducting
may cause major motor damage (not covered by warranty).
WARNING
• USE ONLY GENUINE PREMIER CLEAN DOUBLE LINER BAGS WHICH PROUDLY DISPLAY THE
GENUINE PREMIER CLEAN LOGO.
• WHEN CHANGING BAG, CHECK MESH UNDER BOTTOM PLATE FOR LINT BUILD-UP,
CLEAN IF REQUIRED.
DO NOT VACUUM PLASTER DUST, CONCRETE DUST, BRICK DUST, TALCUM POWDER
OR ANY LIQUIDS.
FAILURE TO COMPLY WILL VOID ANY IMPLIED WARRANTY.
ALL COMMERCIAL APPLICATIONS - ONE YEAR WARRANTY

6
9mt Standard Hose & Tool Set
2 Way Brush
For use on carpets and vinyl/tiles.
Not recommended for floorboards, slate etc
Telescopic Wand
Adjustable to the height you desire, simply push the
button and extend to desired length.
Dusting Brush
Can be used just about anywhere.
Shelves, blinds, lamps, tables and window sills.
Upholstery Brush
This brush comes with removable brushes and
can be used on couches, curtains, rugs and mattresses.
Crevice Tool
Use for narrow spaces between couches,
window panes, hard to reach areas.
Please Note: Compact units do not come with upholstery brush
Accessories
www.premierclean.com.au

7
9mt Switch on/off Hose & Tool Set also comes with
Hard Floor Brush
For use on any hard surfaces.
Floor boards, vinyl, slate, bricks and rugs.
Hose Hanger
Ideal to hang your hose on.
Switch Variable Hose
Contol your unit from where you stand. Turn the unit on or
off or select from two suction levels. Turn the suction to low
for fine rugs and hard floor surfaces and turn the suction to
high for carpets. No more running back to the wall to turn
the unit off.
Optional extras Vac Socks to protect walls, accessory
hanger to hang your tools on and much more log onto
www.premierclean.com.au or 1300 881 608
for your nearest dealer.
Hose Sock - Available in 9mt and 12mtTK270 Power Brush
www.premierclean.com.au

8
There is no maintenance to be performed on the actual motor of your ducted
vacuum. The most important tips for a longer vacuum life are - to keep the
inside of the unit (canister) itself clean - make sure you do not vacuum up any
harmful dusts or ANY liquids (see pg 5 for complete list). Should you require a
service to your unit please contact the dealer who you purchased the unit from
or call us on 1300 881 608 to find a dealer near you.
Changing Bags and Filters
WARNING
“FAILURE TO USE PREMIER CLEAN DOUBLE LINER FILTER
BAGS WILL CAUSE MOTOR FAILURE AND VOID WARRANTY”
Motor
BIN
LOW VOLTAGE
ONNECTION
OVERLOAD
SECONDARY
FILTER
WEIGHTED
FILTER
SWITCH
PREMIER
UNIT
PLATE OVERLOAD
SWITCH
LOW VOLTAGE
CONNECTION
BAG
ADAPTER
MONARCH
UNIT
BIN
BAG ADAPTER
LOW VOLTAGE
CONNECTION
OVERLOAD
SECONDARY
FILTER
SWITCH
PREMIER
UNIT
Monarch 250, 490, 550, 650, 850
Compact 2, Typhoon
Lift lid and remove bag from bag adaptor (be
careful not to pull bag adaptor off with the bag and
throw away). Insert new bag and replace bin. If
bag is broken or split, lift bottom plate and clean
around airway to the motor and replace plate, wipe
inside unit with a cloth to remove excess dirt.
Premier 250, 490, 550, 650, 850
(3000, 4000, 5000, 6000 if taken the
option to use as a bag system)
Unclip bottom bin and remove bag from bag
adaptor (be careful not to pull bag adaptor off
with the bag and throw away). Insert new bag
and replace bin. If bag is broken or split, clean
secondary filter located above the bag.
Premier 3000, 4000, 5000, 6000
Bagless model
Unclip bottom bin and remove dust canister
empty contents. Remove weighted filter clean and
replace, check secondary filter if dirty clean and
replace. Weighted filter to be replaced once a year,
secondary filter to be replaced every two years.

9
Troubleshooting
Problem Cause Action
Suction strength
has decreased
Bag or canister is full
Units lid or canister not
replaced properly
Something stuck in the
vacuum pipes
Replace bag with new one.
Check the airway to the motor
and make sure it’s clean.
Locations as below
Monarch series under the
bag down the bottom of the
unit.
Premier Series above the
bag.
Premier Bagless Series
dirt to be empty and change
or clean filters
A ducted vacuum needs sealed
vacuum. Make sure the lid or
canister has been put back on
securely.
If you have a point on the unit
in the garage open the point
and turn the unit on at the
switch on the side. If there is
a lot of suction you most likely
have a blockage in your pipe.
If there is low suction check the
above two actions. Contact
1300 881 608 for your
nearest service department.
Vacuum will
not stop
Hose not properly
inserted into vacuum
inlet
Ensure that the hose is inserted
with arrow facing upwards for
switch hoses only
Vacuum will
not start up
The electrical power is
not connected properly
Ensure that the power cord is
plugged into a working power
point and is switched on

10
WARRANTY –
CUSTOMER COPY
Premier Clean Pty. Limited
Manufacturers of PREMIER
CLEAN
Factory 4/1 Merri Concourse,
Campbellfield, Vic 3061
Premier Clean Pty. Limited
ABN 70 005 225 794
warrants its PREMIER CLEAN
VACUUM SYSTEMS (PREMIER/
MONARCH UNITS)
Electric Motors for a period
of 36 months from the date of
purchase against proven defects
in workmanship and materials.
Premier Clean Warrants
Compact 1, Compact 2 and
Typhoon units Electric Motors for
a period of 12 months from the
date of purchase.
Premier Clean undertakes
to exchange or repair any
part proven to be defective
within the relevant warranty
period PROVIDED THAT the
product has not been modified,
tampered with or repaired
by any person other than
an authorised employee or
dealer and has been used in
accordance with the instructions
supplied. The warranty does
not extend to defects caused by
accident, misuse, abnormal use,
neglect, normal wear and tear,
or connection to incorrect power
supplies. Any parts exchanged
may be either new or rebuilt at
Premier Clean’s option.
THIS WARRANTY
IS SUBJECT TO
THE FOLLOWING
CONDITIONS:-
1. WHERE THE PRODUCT
WAS INSTALLED BY AN
AUTHORISED PREMIER
CLEAN DEALER OR AGENT
(a) Labour and Parts – For
a period of ninety (90) days
from date of purchase, the
Premier Clean Dealer or Agent
who installed the product
shall remove and repair or
replace the defective part
free of charge, but any cost
associated with travel outside
the metropolitan area is NOT
INCLUDED and shall be paid by
the Purchaser.
(b) Parts only – For the
remainder of the relevant
warranty period any defective
part will be repaired or
replaced if taken or delivered
(inward and return freight
pre-paid) to the Premier Clean
Dealer or Agent from whom
the goods were purchased, but
the cost of labour in respect of
on-site repairs, removal or re-
installation by the Premier Clean
Dealer or Agent and the cost of
factory or workshop time shall
be paid by the Purchaser.
2. WHERE THE PRODUCT
WAS NOT INSTALLED BY
AN AUTHORISED PREMIER
CLEAN DEALER OR AGENT
(a) Labour and Parts – For
a period of ninety (90) days
from date of purchase any
defective part will be repaired
or replaced if taken or delivered
(inward and return freight
pre-paid) to the Premier Clean
Dealer or Agent from whom
the goods were purchased, but
the cost of labour in respect of
on-site repairs, removal or re-
installation by the Premier Clean
Dealer or Agent, and the cost of
factory or workshop time shall
be paid by the Purchaser.
(b) Parts only – For the
remainder of the relevant
warranty period any defective
part will be repaired or
replaced if taken or delivered
(inward and return freight
pre-paid) to the Premier Clean
Dealer or Agent from whom
the goods were purchased, but
the cost of labour in respect of
on-site repairs, removal or re-
installation by the Premier Clean
Dealer or Agent and the cost of
factory or workshop time shall
be paid by the Purchaser.
GENERAL EXCLUSIONS
Premier Clean specifically
excludes from this warranty
any liability whatsoever in
respect of defects caused by the
incorrect installation of Premier
Clean Vacuum System whether
performed by an authorised
Premier Clean Dealer or Agent
or any other person or persons.
In addition, Premier Clean
specifically excludes any liability
whatsoever in respect of any
loss, damage or consequential
loss or damage whatsoever
caused during or resulting from
such installation.
UNITS OF VACUUM
SYSTEMS WHICH
SPECIFICALLY REQUIRE
FILTER BAGS TO BE USED
ARE EXCLUDED FROM THIS
WARRANTY UNLESS FILTER
BAGS ARE USED. THESE
MUST NOT BE USED TO
VACUUM LIQUIDS, BRICK,
CONCRETE, PLASTER
OR SIMILAR DUST. THIS
WARRANTY COVERS
DOMESTIC USE ONLY.
PROOF OF PURCHASE
Proof of purchase in the form
of the product warranty card
and/or invoice is a condition of
this warranty and without such
proof this warranty shall not
bind Premier Clean.
No term of this warranty
purports to exclude,
restrict or modify the
application of any of the
provisions of Part V of the
Trade Practices Act 1974
or of Part IV of the Goods
Act 1958 (Victoria).
If assistance is required in
understanding the terms and
conditions of the warranty you
should contact either the Dealer
from whom the product was
bought or the Company.
Warranty

11
Purchase Receipt
Please Complete and Return by Post or visit us at
www.premierclean.com.au and complete online
Purchase Date
Model
Serial No.
(this is found on the top left hand side of the vacuum unit)
Dealer Name
Store/Address
Purchaser’s Name
Purchaser’s Address
Phone
For your future reference
Dealer Name
Dealer Phone Number
Address
Date of Purchase

Head Office
Factory 4/1 Merri Concourse,
Campbellfield, Vic 3061
PH: 1300 881 608
WEB: www.premierclean.com.au
E-MAIL: [email protected]
Factory 4/1 Merri Concourse,
Campbellfield, Vic 3061
✁