PRESONUS DIGIMAX D8 Instruction and safety manual

STAGE
DigiMax D8 rear
DigiMax D8 rear
DigiMax D8 rear
FireStudio Lightpipe front
FireStudio Lightpipe rear
FOH Digital Console Analog Monitor Mixer
24 Channel TRS-TRS snake
24 Channel XLR (F) - XLR (M) sanke with Stage Box
75 ohm BNC
75 ohm BNC
75 ohm BNC
ADAT
BNC T-Connector
(F-F-F)
BNC T-Connector
(F-F-F)
BNC T-Connector
(F-F-F)
FW400 cable
Laptop
This diagram shows the DigiMax D8 used as a splitter; sending the analog direct outputs to an analog monitor mixer and the ADAT output to a digital
Front of House console. The digital outputs of the FOH console are then being sent to the FireStudio Lightpipe so that the performance can be recorded
on a computer. The entire digital signal path is being clocked to the digital console via BNC, so the 3 DigiMax FS and the FireStudio Lightpipe must be
set to clock externally via BNC. Because of the compact size of the DigiMax D8, it is necessary to use a BNC T-Connector with 3 Female inputs, rather
than the standard Male - Female - Female iteration when using both parallel wordclock distribution and all 8 direct analog outputs at the same time.
FireStudio Lightpipe Mixer set to
clock externally via BNC
FireStudio Lightpipe Mixer set
to Terminate BNC
Using the DigiMax D8 as a Preamp Split
PreSonus Audio Electronics | 7257 Florida Blvd, Baton Rouge, LA USA | Tel: [phone] | Fax: [phone] | www.presonus.com | [email protected]
What you will need:
1 24 Channel XLR Snake with Stage Box
1 24 Channel TRS - TRS snake
7 75 ohm BNC cables
3 F-F-F BNC T-Connectors