Prima PRAE0030 Reference manual

Cod:0103082466
Extractors
PRAE0030

2
Important
The manufacturer cannot be held responsible for injuries or losses
caused by incorrect use or installation of this product. Please note
that the manufacturer reserve the right to invalidate the guarantee
supplied with this product following incorrect installation or misuse
of the appliance or use in a commercial environment.
This appliance is not designed to be used by people (including
children) with reduced physical, sensorial or mental capacity, or
who lack experience or knowledge about it, unless they have had
supervision or instructions on how to use the appliance by someone
who is responsible for their safety.
Under no circumstances should any external covers be removed for
servicing or maintenance except by suitably qualified personnel.
Appliance information:
Please enter the details on the appliance rating plate below for
reference, to assist Customer Care in the event of a fault with
your appliance and to register your appliance for guarantee purposes.
Appliance Model
Serial Number
CE Declarations of Conformity:
This appliance has been manufactured to the strictest standards and
complies with all applicable legislation, including Gas safety, Electrical
safety (LVD) and Electromagnetic Interference Compatibility (EMC).

3
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must be taken to a special
local authority waste collection centre or to a dealer providing
appliance recycling services.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health. It also
enables the constituent materials to be recovered, saving both energy
and resources. As a reminder of the need to dispose of household
appliances separately, the product is marked with a crossed-out
wheeled dustbin .
Please note:
•Under no circumstances should the extractor be connected to any
gas ventilation system, flue system or hot air ducting system.
• Do not vent the extractor into an attic or loft space.
•Only install the extractor in rooms with adequate ventilation.
Remember that the extractor is powerful and whatever air is
extracted needs to be replaced.
•Do not tile the extractor in. It should be removable for service or
maintenance.
•If these instructions are ignored and the hood cannot be repaired
if faulty, a replacement is not an option under warranty.
•Do not use silicone sealant to secure the extractor to the wall.
•If these instructions are ignored and the hood cannot be repaired if
faulty, a replacement is not an option under warranty.
•You must be able to isolate the extractor from the mains electrical
supply after installation.

4
•Steam cleaners must not be used when cleaning this appliance.
•The performance of your extractor will vary depending on a number
of factors. These include: type of extraction, length of ducting, room
volume, ventilation available and cleanliness of the filters.
Note:
For best performance, you should switch on the extractor 15 minutes
before starting to cook and leave it to run for approximately 15
minutes after the end of cooking.
•This extractor has been designed to be used in a room with a
volume of less than 36m .

Power Key

6
Care and Maintenance
IMPORTANT : DO NOT PERFORM
MAINTENANCE OR CLEANING OF
THE EXTRACTOR WITHOUT FIRST
SWITCHING OFF THE ELECTRICITY
SUPPLY.
Cleaning
You should use a nonabrasive cleaner.
Any abrasive cleaner (including Cif) will
scratch the surface and could erase the
control panel markings.
by simply using a dilute solution of
water and mild detergent and drying to
a shine with a clean cloth.
The grease filter should be kept clean
to minimise the risk of fire.
At least once a month you should
remove the grease filter and clean
it with hot soapy water. You can also wash the grease filter in a
dishwasher, ensuring that you place it in an upright position to prevent
damage from other items in the dishwasher.
Fig. 4
Fig. 5
Fig. 3

7
•Open the hinged panel as shown in Fig. 3.
•Push in the button on the handle and then pull down on the filter at
the top as shown in Fig. 4.
•When you have released it at the top, then you can pull the filter out
completely.
After rinsing and drying, reassemble the grease filter to the hood by
reversing the removal process.
Please note:
Cleaning the grease filter in the dishwasher may lead to
discolouration. This is normal and does not constitute a fault with the
appliance.

8
Charcoal filter installation
Care and Maintenance
IMPORTANT: DO NOT ATTEMPT TO MAINTAIN
OR CLEAN THE EXTRACTOR WITHOUT FIRST
SWITCHING OFF THE ELECTRICITY SUPPLY.
Fig. 6
Fig. 8
Fig. 7
In re-circulating mode, air is vented back
into the kitchen through the opening in
the cooker hood.
This method is advised if you are not
using your hob intensively.
Re-circulated air requires the use of
charcoal filters to remove odours.
These are included with the cooker hood.
Attention: the cooker hood leaves the
factory fitted with a charcoal filter.
If you wish to use the ducted method,
please remove the charcoal filter first
before attempting to do so.
Note: This charcoal filter is non-washable and must be replaced as
required. To install a new charcoal filter, first remove the grease filter,
as shown in Fig.7.
To ensure the best performance from
your cooker hood, the charcoal filter
should be replaced every 3-4 months,
dependent on use.
Check with your local retailer or dealer
for information on how to obtain
replacement charcoal filters.

Changing the Light
NOTE: LED lights replacement must
be done by a qualified electrician.
Disconnect the mains plug in order to
interrupt flow of electricity.
Take out the grease filter and open the
black protective cap of the plug-in
connection from inside.
Loosen the plug-in connection contained
therein.
Carefully loosen the defective LED
module downwards and replace the
LED.
Connect the plug-in connection and
close the external protective cap.
Connect with power supply again.
Fig. 9
9
Fig. 10
Fig. 11

10