Primalux LED-PIR 520.001UK User manual

520.001UK User Manual
LED-PIR
Ceiling PIR Sensor
Item ref: 520.001UK
User Manual
Introduction
Thank you for choosing the Primalux PIR Ceiling Sensor for your installation.
The sensor has been designed to help and assist you in saving energy from
your lighting. The occupancy sensor uses infrared motion to detect any
movement and send signals to the lights. Many luminaires can be used in
conjunction with the sensor such as; LED Panels, Downlights and Bulkheads
etc.

520.001UK User Manual
Function
The sensor will automatically identify day and night.
The ambient light can be adjusted to your desired setting.
When the switch is turned to ‘SUN’ (max) the sensor will work
in both at daytime and at night.
When the switch is turned to ‘MOON’ (min) the sensor will only work under less
than 10 Lux.
As for Adjustment please refer to the testing section.
Time-delay adjustment can be altered to your required setting.
Connection Test Figure
Installation
1. Turn off the power
2. Remove the transparent vinyl cover located at the bottom of the
sensor.
3. Loosen the screws in the connection terminal.
4. Connect the power and rated load to connection terminal of sensor
using the connection sketch map.

520.001UK User Manual
5. Tighten the screws and place the vinyl cover back into the correct
location.
6. To install the sensor in the ceiling, fold the metal springs upwards until
they are in a “l” position, then push the sensor into the ceiling hole or
installation box and release the springs to set the sensor in the installed
position.
7. Once installed, connect the sensor to the power and test.
Test
•Turn the ‘Time’ switch anti-clockwise for
minimum.
•Turn the ‘Lux’ switch clockwise for
maximum.
•Once the power is turned on the sensor will take 30 seconds to warm
up and will then enter working mode.

520.001UK User Manual
Note
•When testing the sensor in daylight, please turn the ‘Lux’ switch to
(SUN) position, otherwise the sensor lamp could not work.
•Avoid installing near air temperature systems such as; air conditioning
and central heating.
•Ensure there are no objects blocking the detection window effecting the
detection of movement.
Specification
Power Source …………………………………………….. 220-240Vac (50/60Hz)
Ambient Light ……………………………………….. <10-200 Lux (Adjustable)
Time Delay Minimum ………………….…….. 10 Seconds ± 3 Seconds
Time Delay Maximum ………………………….…. 7 Minutes ± 2 Minutes
Rated Load (Incandescent Lamp) ………………………….… 1200W
Rated Load (Energy-Saving Lamp) …………….…………..... 300W
Detection Distance …………………………………….…… 6m MAX (<24°C)
Detection Range ………………………………………………………….……. 360°
IP Rating ……………………………………………………………………………… IP54
Working Temperature ………………………………………….. -20~+40℃
Working Humidity ………………………………………………….…… <93%RH
Installing Height ………………………………………………………... 2.2m~4m
Power Consumption ……………………………………………………. < 0.9W
Errors and omissions excepted.
Copyright© 2019. AVSL Group Ltd.