Primo Water PSM-40E User manual

PSM-40E 50E 60E 80E 120E 160
Spiral Mixer
USER MANUAL
General Description
Thank you for using our PSM Spiral Mixer.
This machine used for paste mixing. It applies the advanced microcomputer control system.
It uses manual and automatic control system. It has two speed controls, easy-operating, safe
and convenient. Paste can absorb large amount of water, and the machine increases temperature
slowly. This machine is ideal equipment for hotel, cabaret, bakery and food-machining factory.
Main External Parts of Mixer
01
03
04
05
07
08
09
06
02

①、Control plate: Rabbit stands for high speed, Turtle stands for low speed, Clock stands
for timer, Hand stands for manual, and Arrowhead stands for reverse.
②、Safety guard
③、Bowl
④、Cover
⑤、Protective wheel
⑥、Switch
⑦、Body
⑧、Support
⑨、View Hole Cover
Operation Instruction
The machine has two controls: touch-panel control and manual-switch control
1. Touch-panel control
A. Put the materials into the bowl. Note that sufficient quantity is 55% of bowl volume with
flour and water.
B. Automatic manner: switch on power supply; set 3-4 minutes at low speed, 7-8 minutes at
high speed, and press “manual/automatic switch”to automatic state (“AUTO” light became
light on the panel). Then press “ON” to turn on the machine, the machine will mix the flour at
one time.
C. Manual manner: switch on power supply, press “manual/automatic switch”to manual
state (“Manu” light became light on the panel). Press “quick/slow switch”at low speed, and
press “ON”switch to start mixing at low speed, and to some extent, press “quick”mixing
switch to complete mixing.
D. Take out paste after mixing. If turn on the face guard during mixing, then the machines
will stop rotating. In this case, press “INCH”switch, then the machine can operate, and the
paste can be taken out.
2、Manual-switch control
The machine has manual switch at the left side, “1” is slow speed, and “2”is quick speed.
The switch can be turn to the required speed when using, and press the button beside the
switch.
In the process of manual operation, the power supply of panel is turn off. If you want to use

it again, then switch on the power supply again.
3. The machine has slow or quick reversion function, and it can be used in blending the
materials. When taking out the paste, reversion function can’t be used in case of breaking the
paste.
4. At any times, if happens some accidents, press “Emergency Button”to stop the machine
quickly to prevent any damage. The machine can be started again after finding out the reasons.
Notes
1. The mixer must have good protective grounding.
2. Don’t operate the mixer beyond the required quantity. When the quantity of water is
below 55%, please reduce the flour.
3. If use ice, please use shivers.
4. Do not put the hand into the bowl when operating the mixer.
Maintenance
Take out the paste after mixing; wipe the inside of bowl, newel and pole with clean water
and cloth. And move the unwanted materials above the bowl with clean cloth. Do not wash the
below area of the machine.
1. Wipe the panel with clean cloth with litter water; do not use toluene, gas .ect volatile
cleaner to clean the panel.
2. Do not use nail or other hard things to press the button. Do not wash the panel and switch
with water in case of electric shock.
3. Make sure the machine works in a stable position, if it has some shakes, then adjust the
adjustable foot to make the machine in stable.
4. Put the butter into every butter hole in the bearing three months a time.
Easy trouble and solution
1. The machine can’t start up:
①Check the power supply, whether lose phase or not.
②Check the fuse, if burnt, please replace it.
③Switch, emergency button and other buttons are in close or open.
2. The machine can’t work normally, the belt often became flexible and slip, please adjust the
belt.

Technical Data
5659 Royalmount Ave.
Montreal, QC H4P2P9
Tel: [phone]
Fax: [phone]
12000 Biscayne Blvd. Ste108
Miami, FL 33181
Tel: [phone]
Fax: [phone]
[email protected]