
223
QUICK START
•Always turn the light bulb base to“OFF”after playing to conserve battery life.
• Remove the clear portion of the light bulb from the base before washing. Rinse with mild dish
soap and water only. DO NOT expose the light bulb base to moisture of any kind.
• Place the light bulb and light bulb cap with owl stem on a towel to air dry after rinsing.
• DO NOT wash doll’s hair with water and/or soap.
• DO NOT dry doll’s hair with a hair dryer or subject hair to very high heat in any manner as it will
irreparably damage the hair.
• The light bulb is to be used with water only when it is fully assembled in accordance with the instructions.
IMPORTANT INFORMATION
NOTE: Before beginning, cover the play area to avoid possible water and oil damage.
An adult must install fresh alkaline batteries in your light bulb should the batteries need replacing.
Here’s how:
1. Using a Phillips screwdriver (not included) remove the screw battery compartment cover
from under the light bulb base.
2. Install three (3) 1.5V AG13 (LR44) alkaline batteries (not included) making sure the (+) and
(-) ends face the proper direction as indicated inside the battery compartment.
3. Replace the compartment cover and tighten the screw.
• Use alkaline batteries for best performance and longer life.
• Use only the type battery recommended for the unit.
• Batteries should be replaced only by an adult.
• Insert batteries with the correct polarity ( + and – ).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable(nickel-cadmium) batteries.
• Do not short-circuit batteries.
• When not used for an extended time, remove batteries to prevent possible leakage
and damage to the unit.
• Do not mix rechargeable and non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before charging.
• Rechargeable batteries are to be recharged only under adult supervision.
• Do not recharge non-rechargeable batteries.
• Exhausted batteries are to be removed from the toy.
• Do not dispose of batteries in fire as they may leak or explode.
12
34
Twist off the light bulb cap
and the light bulb from the base.
Glycerine
Water
56
REPLACING THE BATTERIES
SAFE BATTERY USAGE
Twist off the light bulb from the
light bulb cap with owl stem.
Hold the light bulb upside down. Fill the bulb
3/4 full of distilled water. Fill the remaining 1/4
with glycerine. Leave space at the top to
prevent spillage when re-inserting the stem.
Add a few dashes of glitter to the
light bulb.
Insert the owl stem into the light bulb
and firmly twist on the light bulb cap.
Twist the light bulb and light bulb cap
onto the light bulb base.Turn on the
base to illuminate your creation!
move
switch to
“ON”
3 x 1.5 V
AG13 (LR44) Batteries
ON
OFF
ON
OFF