ProJet Nitro-O03 User manual

nritro-Oos \ T?F
RADIO CONTROLLED AIRPLANE
INSTRUCTION MANUAL A SAFETY PRECAUTIONS
This radio control model is not a toy!
OFirst-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce
its performance to full extent.
(DAssemble this kit only in places out of children's reach!
OTake enough safety precautions prior to operating this model.
You are responsible for this model's assembly and safe operation!
OAlways keep this inskuction manual ready at hand for quick
reference, even after completing the assembly.
SPECIFCAIIONS
Wingspan
Lenght
Weight
Wing Area
Wing Loading
Radio Control
Motors
ESC
1300mm
1660mm
900-1^0009
30 dm'
30-349 dm2
3 Ch 2 Servos
2835-3035
20-30A
PROKreffiW
.#

BEFORE YOU BEGIN
Assemble left and right sides
the same way.
rel
Cut off shaded portion.
Must be purchased separately! Drill holes with the specified
diameter (here: 2mm).
Pay close attention here!
%l orr,repoxy srue.
Do not overlook this symbol!
G iT,t'.fi jf; ?,"lliJs!;Blii',i.ss Apply instant glue (CA glue, super glue).
ELEVATOR
Please cut here for the
largest degree.
A)
t/- @
gr
5i
t-{
Securely glue together.ll coming off during flights,
you lose control of your airplane which leads to accidents!
NF: '1020 Control Horns
2 x 1Smm Screw
o
Be sure to apply instant
type CA glue to
both sides of each hinges.
(low viscosity type)
RUDDER
Please cut here for the
largest degree. 6\
\\ NF: 1o2o controt Horns
\\ 2
2 x 15mm Screw
CIumurmttrmmmm 2
Be sure to apply instant
type CA glue to
both sides of each hinges.
(low viscosity type)
2

Fuselage
l!
Y ,=r'/
Fuselage
0.4 x 3M Wire
3

Wire
2 x 8mm Round brass tube
ELEVATOR RUDDER
129 Micro Servo
9
o t---l ? t 9_ll 1:y.19 91?!: qqe 4
Servo
1.3mm Riooino Couolers r
E=lM----l--------Y-"---Y-----.',.-. T
F=::- NF: 1021 Clevis
@ l---l ? l9-" Round brass tube o
NF:1021 o.4mm wire
2 x 8mm Round brass tube
4

Fuselage
o
I
I
a
I
I
Plywood 53mm
1
fl rusetage
-re
2.6 x 12 mm TP Screw 2.6x12mm
Fuselage
5

F
2.6 x 12 mm TP Screw
{t

Control Surface Movement
Secure foam padding with
rubber bands or tape as required.
Carefully install the receiver and battery pack to
ensure that they will not shift during flight.
Adjust the travel of each control surface to the
values in the diagrams.
These values fit general flight capabilities.
Readjust according to your needs and flight level.
Never fly before checking the CG's requlred position.
15-25mm
RUDDER 0mm
15-25mm
C.G
80-85mm
ELEVATOR
7