Promax Transport Tank 1200L User manual

Promax Transport
Tank Handbook
Freephone 0800 77 66 29 | [e-mail] | www.promaxplastics.co.nz

Contents
01 Introduction
02 Frame Design
03 Liquid Surge
04 Fabrication Details
05 Tank Fitting Locations
06 Things that will void Warranty
Freephone 0800 77 66 29 | [e-mail] | www.promaxplastics.co.nz

Introduction
Congratulations on your purchase of a Promax Transport Tank
Please read your operators handbook carefully
before using your unit.
Ideally suited to water cartage for contractors,
farmers, earthmovers, landscapers, potable water
carriers and many other applications.
Warnings
• When mounting to any vehicle ensure that
you have read the Vehicle Owner’s Manual and
that you comply with all the weight restrictions
as specified by the vehicle manufacturer, as
overloading can cause injury or death
• To ensure your own safety and that of your
employees if applicable you must comply with
all relevant environmental, work place health and
safety legislation and codes of practice
• Ensure tank is firmly secured in an appropriate
manner. Where applicable tank mounting may
need to be designed /approved by an engineer
• Care should be taken at all times, particularly
when operating on rough or steep terrain Drivers
should be aware of water surge at all times
• WHS requirements for working at heights must
be complied with as applicable
• Personal Protection Equipment must be worn if
required
• Improper or careless use of this tank can cause
serious injury or death. Minors should never be
allowed to use this tank
• Tank is a confined space. Ensure compliance with
WHS requirements if entering tank
• You must be in good mental health to operate
this tank and not be under the influence
of alcohol or any drugs that could impair your
vision, physical strength, dexterity, judgement, or
other mental capacity
Freephone 0800 77 66 29 | [e-mail] | www.promaxplastics.co.nz

Transport Tank
Overview/Frame Design
Tank Warranty is conditional on tank being correctly mounted.
Where applicable mounting may have to be designed and/or approved by
an engineer.
Freephone 0800 77 66 29 | [e-mail] | www.promaxplastics.co.nz

Fabrication details
of Tank Skid
Freephone 0800 77 66 29 | [e-mail] | www.promaxplastics.co.nz

Tank Fitting
Locations for Tanks
Placing fittings in locations other than those recommended may result in
failure or damage and void warranty. Only use approved fittings: brass,
poly, poly welded 1” – 6”. Only tanks 10,000 litres and above can accept
fittings larger than 4”.
fittings larger than 4”.
Fitting Suggestion
Freephone 0800 77 66 29 | [e-mail] | www.promaxplastics.co.nz

The following things will void warranty.
Abuse Failure as a result of neglect, such as improper
operation. Lack of maintenance or continued
operation after discovery of a defect that leads
to further damage.
Alterations Any unauthorized alteration, modification,
attachments or unauthorized repair to
equipment.
Clean-Up Time Promax does not pay for cleaning of products,
parts or accessories or work area before or after
the warranty repair.
Damage Damages or machine/component failure caused
by carelessness/recklessness or accidental
damage, improper operation, excessive speed,
inappropriate storage or transportation.
Environmental
Conditions &
Application
Deteriorated or failed components such
as o-rings, diaphragms, hoses, seals and
connections damaged by corrosive chemicals,
dirt and sand, excessive heat, moisture or other
environmental impacts. Warranty determination
on these type of failures will be made by Promax,
only after inspection of the failed component.
Inability/
Unsuitability
In no event shall Promax be liable to any person
for indirect or consequential damages or for
injury or commercial loss resulting from any use
or inability to use any Promax product.
Maintenance Component failure due to failure to perform
maintenance services such as, oil and grease
changes/top-ups, failure to clean tanks, pumps
filters, nozzles and spray lines. Failure to tighten
or replace loose or missing bolts, nuts, fittings,
shields and covers.
Non-Genuine Parts Use of parts other than Promax parts for repair
of warranted items will automatically negate
any warranty. Warranted components must be
replaced with genuine parts.
Freephone 0800 77 66 29 | [e-mail] | www.promaxplastics.co.nz