ProxiMity UV-CLEAN User manual
Prior to proceeding with the following manual please notice this update:
Long Short
0 degrees
15 degrees
(FLAT SQUARE)
This part will minimize
free rotaon.
Long screw
holds rotation position with a
small amount of pressure.
Tighten until firm only.
Note:
Rotaon Stop
Please see that part (A) will be included with and attach
to your device. Used instead of (C) below.
A.
C.
7/20 Rev 0
Long Short
0 degrees
15 degrees
(FLAT SQUARE)
This part will minimize
free rotaon.
Long screw
holds rotation position with a
small amount of pressure.
Tighten until firm only.
Note:
Rotaon Stop
A.
C.
some angled screens and screens bezels.
7/20 Rev 0
Illustration of previous instructions
Screw will press
in these two areas.
Position in the
hole
Behind
the white
motion
sensor
lens. So the
tape contacts the
shell.
Bottom view
This part will act as your rear rotation stop.
i.
Made in the U.S.A
proximitysystems.com/uvclean
PRODUCT GUIDE
Made in the U.S.A
proximitysystems.com/uvclean
Proximity UVC-SM
PRODUCT GUIDE
REV F /2020
Made in the U.S.A
REV F /2020
Proximity UVC-SM
CONTENTS
1. Quick Guide
2. Safety & Disposal
3. Set-Up
4. How It Works
6. How It Works, Audit Records
7. Warranty Terms
Proximity UVC-SM
QUICK GUIDE
REV F /2020P1
supplied adapter, or another USB 3.0 device with output power of 900 mA.
Set-up is complete.
4
1. Status
Indicator
5. Micro-USB
Data
Receptacle
feature
stored internally
4. Power
Receptacle
White = On, Stand By
2
135
4
Rear iew
Front iew
UV-C Unit
White = On, Stand By
Power
5mm , USB-A
Power Supply
Micro-USB
3/32” Allen Key
Short
Screw
(X1)
Screw
(X1)
Stand
Bracket
thin monitors
System Requirements
Proximity UVC-SM
SAFETY & DISPOSAL
REV F /2020P2
search.earth911.com
www.epa.gov
Federal Universal Waste Rule
www.lamprecycle.org
baeryresponsibility.org/baery-recycling
device is at room temperature only.
SAFETY & DISPOSAL
Do not use this device on people, food, or pets.
outdoors.
www.lamprecycle.org/state-local-laws
UV Bulb
Proximity UVC-SM
SET-UP
REV F /2020P3
( OPTION A. ) ( OPTION B. )
Place the stand
. Between the
the main
Long
Short
Long Short
(FLAT SQUARE)
Long screw
holds rotation position with a
small amount of pressure.
Tighten until firm only.
for
thin
Two sided adhesive is preinstalled.
Remove the adhesive paper.
with the front face of the monitor
or device, press down on the metal
(supplied adapter
or a USB 3.0.)
Power is on.
Proximity UVC-SM
HOW IT WORKS
REV F /2020P4
Area
0o
15o
Rotational Adjustment for Tilt
-
Max.
12.00”
28.00”
10.00”
24.00”
13.00”
20.00”
20.00”
7.00”
It has
Clean Time
movement. Factory set to 15 seconds.
Wait Time
Factory set to 60 minutes.
7.0
4.0
10.0
12.0
12.50
22.00
24.00
24” monitor
Parallel
Proximity UVC-SM
HOW IT WORKS
REV F /2020P5
Clean Time
is 240 or 300 seconds.
Wait Time
Save to Device
Set Device To Local Date & Time
located on the Home
Date & Time
(1)
(2)
Proximity UVC-SM
HOW IT WORKS
REV F /2020P6
The area under the
• Date
• Time
clean me (page 4).
Completed
Interrupted
Bulb Failure
Refresh From Device
Records
(3)
(4)
Proximity UVC-SM
WARRANTY TERMS
REV F /2020P7
3”
15°
3.1”
2”
6.13”
6”
1.7” 1.4”
6.13”
5.5”
.76”
2.3”
imited Warranty
Proximity System, Inc (hereaer referred to as ‘Proximity) warrants its manufactured products
t
o e free of defects in materials and workmanship under normal use and service to the oriinal
p
urchase for one (1) year from the date of purchase. Unauthorized modicaon or alteraon of the
p
roduct, improper installaon, and failures from inadeuate inspecon, maintenance or ause of the
p
roducts will void this warranty. If any Proximity manufactured product is or ecomes defecve durin
t
he warranty period, Proximity will, at its opon, either repair, exchane or replace defecve unit. The
p
urchaser should contact our Service Department for service. Proximity reserves the riht to make
d
esin chanes in manufactured products uilt and/or sold y them at any me without incurrinany
o
liaon to make the same or similar chanes to previously desined/uilt and delivered units.
P
roximity reserves the riht to chare for replacement warranted parts or those parts which are found
t
o have failed due to unauthorized modicaon or alteraon of the product, improper installaon,
i
nadeuate inspecon or maintenance, damae in transit, or ause of the product. Photos and or
a
ddional informaon may e reuested to idenfy defecve parts. Proximity reserves the riht to
m
ake modicaons and improvements to products that may create sliht dierences in the manual
d
escripons and illustraons.
This uide and any informaon provided are the property of Proximity Systems and not for re-
u
se or pulicaon without wrien consent from Proximity Systems.
Proximity Systems, Inc
11301 Boudreaux Rd.
Tomall, TX 77675-7431
-Mail AddressustomerService@proximitysystems.com
1-00-437-111
Table of contents
