Regency 600WT2436KIT User manual

STAINLESS STEEL
COMMERCIAL WORK TABLE WITH
UNDERSHELF AND OVERSHELF,
DRAWER, AND POT RACK
INSTALLATION GUIDE
03/2022
600WT2436KIT, 600WT2448KIT
REGENCYTABLESANDSINKS.COM

2
5
1
3
4
Set the tabletop upside down on a surface that won’t scratch it before assembling the drawer.
Flip the drawer over and align it where you want to mount it.
Try this once with the drawer in the frame to make sure the door will clear the lip of the table. If it doesn’t, you’ll
need to shim with some nuts between the hat channel and the brackets.
Aach the Z bracket
to the top of the
frame with screws.
Make sure that the
top of the bracket
goes outward and
the bracket extends a
bit further back than
the rear of the frame
(holes get mounted to
the drawer).
Drill holes in the
hat channels and
aach the drawer
to the table with
self-tapping sheet
metal screws.
INSTALLATION GUIDE
DRAWER ASSEMBLY INSTRUCTIONS
REGENCYTABLESANDSINKS.COM

INSTALLATION GUIDE
REGENCYTABLESANDSINKS.COM
WORK TABLE ASSEMBLY INSTRUCTIONS
1 4
2
3
5
6
Parally ghten
the set screws.
Full ghtening
will come later.
On each of the legs, mark the height
where you’ll be installing your undershelf.
It should be at least 6 inches o the
ground for food safety.
Adjust the feet as
needed to meet your
height requirements
or to compensate
for uneven
ooring.
Flip the table
over and
peel o the
protecve
lm.
Once marked, slide the shelf onto the legs and
fully ghten all of the set screws.
Insert the legs into the tabletop gussets.
You may need to loosen the set screw if one
struggles to go in.

INSTALLATION GUIDE
REGENCYTABLESANDSINKS.COM
OVERSHELF ASSEMBLY INSTRUCTIONS
B
C
1
3 4
2
Align the two L-brackets (A) with the back of
the table and pre-drill holes through the side of
the tabletop for screws. Screw L-brackets into
the table (screws not included).
Slide the midshelf (D) into place and secure it
using the set screws.
Add the overshelf top (E) and secure the legs into
the gussets with the set screws. You may need to
loosen a set screw if one struggles to go in.
Secure the four legs (B) to the L-brackets using
the Allen wrench and set screws (C) provided.
A
D
E