PSiO Noisebuster Instruction manual

PSiO Noisebuster Headphones
Quick Start Manual

Headphones controls
1. Volume up button: Press and hold to increase the sound volume. When
the maximum volume is reached, an acute beep is emitted.
This button also allows you to go back to the previous track: to do this,
briefl y press the button.
2. Volume down button: Press and hold to reduce the sound volume.
When the minimum volume is reached a low beep is emitted.
This button also allows you to skip to the next song: for that, briefl y
press the button.
3. Ignition, stop, play, pause and call button (answer or reject)
• To turn the headphones ON or OFF: Press and hold the button until
the blue LED turns red for a moment.
• To start or pause a song, to accept or reject a phone call: Press
briefl y
During a phone call:
• Press the button once to receive the call.
• Press and hold to end or ignore the call.
4. Input for 3.5 mm audio cable to connect to PSiO
(Cable included)
5. Input for micro-USB cable for headphone charging
(Cable included)
6. Button for noise reduction (Noisebuster)
Press the switch, the indicator lights green to indicate that the noise
canceling mode is active.

Manual
If the device you are using with the headphones is not equipped with
Bluetooth, such as PSiO for example, you will need to use the supplied
3.5mm audio cable.
Bluetooth connection with your device
• Press and hold the On / Off button to turn on the headphones.
• Open the Bluetooth settings on your device and look for available
Bluetooth devices nearby.
• Select «PSiO ANC» and follow the instructions on your device.
The headphones can only be connected to one Bluetooth device at a time.
If you have trouble connecting, make sure the PSiO headphones are not
already connected to another Bluetooth device.
If an unwanted connection with a device occurs, cancel the connection in
the Bluetooth settings of this unit.
To remove the link (2 possibilities)
1. Disconnect the headphones in the Bluetooh settings of your device.
2. Or press and hold the On / Off button to turn off the headphones.
Recharging the built-in lithium-ion battery
Insert the micro-USB plug of the supplied cable into the micro-USB port of
the headphones, and insert the end of the cable into a USB port on your
computer or the AC adapter of your PSiO.
When the headphones is charging, a red LED will light up.
The LED turns blue when the charge is complete.
It is recommended not to use the headphones while charging.

WARNING
• Please recharge your battery if you cannot turn on the headphone.
• Please turn off your headphone after your usage to get a longer
battery life.
• Please use the charging USB packaging together with headphone.
• Please do not change the battery.
• Please do not keep headphone in a humid place.
• Please do not expose or toss headphone into fi re. It will probably
cause an accident.
• Please do not try to disassemble the headphone if you are not an
expert.
• Please try not to use the USB charging cable that comes with the
headphone to charge your phone or other high current devices !
• Please do not spread the headphone speakers excessively when
using the device as stretching the headband over 180° may result in
cracking the headband.

www.psio.com
Copyright © 2020 Psychomed.com® S.A. All rights reserved.
PSiO Noisebuster Headphones Manual - Version #2.
PSiO and the PSiO logo are worldwide registred trademarks of Psychomed.com S.A.
International patented n° PCT/EP2011/068407
Contact Us : [email protected].