Puqpress M2 User manual
M5M3 M4M2
QUICK
START
GUIDE
MODEL
2
www.puqpress.com/manuals
6WARNING
For more information see the extended
manual online about safe installation
and operation.
INTENDED USE
The PUQpress is intended as a fully
automatic coffee tamper.
Grounded coffee can be tampered with an
adjustable force.
The PUQpress is intended for indoor use only.
consequences for safety, warranty and
proper functioning.
SAFETY INSTRUCTIONS
6WARNING
•
understood the instructions in this
document before you install or use the
PUQpress. Keep this document for future
reference.
• Only use the PUQpress as described in
this document.
• The PUQpress can only be used by people
persons with reduced physical, sensory
or mental capabilities or lack of
concerning use of the PUQpress in a safe
way and understand the hazards
•
PUQpress. Not doing so may result in the
PUQpress getting damaged.
3
• Cleaning and user maintenance shall not
•
PUQpress itself into water or other
• Always switch off the PUQpress before
performing maintenance or cleaning on
injury.
•
before performing maintenance or
electric shock, or injury.
• Always unplug the PUQpress from the
power source and other equipment if
or injury.
•
cable or plug is damaged. Any required
repairs may only be conducted by
reason, please contact a customer
Using the PUQpress if the PUQpress,
cable or plug is damaged may result in
electric shock, or injury.
6CAUTION
• Always handle the coffee grinder with
two people with care. Not doing so may
result in the coffee grinder getting
damaged.
• Always adjust the lower clamp before
use. Not doing so results in exposure of
•
between the PUQpress base and lower
clamp. Risk to pinch.
•
alterations to the PUQpress. The
manufacturer holds no liability for
damages resulting from failure to
•
bumping. Not doing so results in the
PUQpress getting damaged.
•
cable. Always grasp the plug and pull.
•
•
wet conditions.
•
• Make sure to guide the cables through
bottom. Not doing so may result in the
cables getting damaged.
• Make sure not to use a damp/wet cloth to
clean the tamper base. Grounded coffee
will stick to the tamper base.
4
ADJUSTING THE PORT-A-FILTER CLAMP
1. Slightly loosen the bolts of the lower
2. Pull down the lower clamp.
3.
upper and lower clamp.
4. Rotate the adjustment wheel clockwise
5. Slightly fasten the bolts of the lower
6.
7. Fasten the bolts of the lower clamp with
8.
upper and lower clamp and check if the
9.
start again at step 2.
5
10.
wiggle after adjusting.
SETTING UP THE COFFEEGRINDER
1.
edge of the table or bar where you want
2. Plug the power cable into the
3. Lift the coffee grinder with two people
and guide the power cable of the coffee
grinder from the top to the bottom of the
PUQpress.
4. Place the coffee grinder on the
PUQpress.
6
5. Guide the power cables of the PUQpress
and the coffee grinder through a power
cable entry.
6.
bar or table.
SWITCHING ON
THEPUQPRESS
1. Plug the other side of the power cable
2. Switch on the PUQpress by setting the
on/off switch to I.
USING THE PUQPRESS
1.
2.
upper and lower clamp.
3. The PUQpress automatically starts
tamping the coffee. The contactless
4. Wait until the PUQpress has tampered
the coffee.
5.
ADJUSTING THE
TAMPINGFORCE
Adjust the tamping force by using the
1. Press the up button to increase the
force.
2. Press the down button to decrease the
force.
CLEANING THE PUQPRESS
Clean the housing of the PUQpress with a
damp cloth. Refer to the table for an
Part Cleaning
method
Cleaning
interval
Dry cloth Daily
Dry cloth Weekly
Dry cloth Weekly
Contactless sensor Brush Daily
7
CLEANING THE TAMPER
BASE
1. Press the set button
2. Turn the coffee grinder 90 degrees.
3. Unscrew the tamper base bolt by turning
4.
5. Unscrew the tamper base by turning it
6. Clean the tamper base using a brush or
dry cloth.
7. Screw the tamper base back by turning it
clockwise.
8. Place the bolt.
9. Screw the bolt back by turning the Allen
key clockwise.
10. Turn the coffee grinder back to the
original position.
11. Press the set button again. The tamper
position.
PUQpress is a product of Barista Technology B.V.
Barista Technology B.V.
info@baristatechnology.com
Other manuals for M2
2
This manual suits for next models
3
Table of contents
Other Puqpress Coffee Maker manuals
