PYD Life CE-AUMP15BL User manual

AUTO
MUG
PRESS
V2.0
Mug Press for 11 - 15oz Mugs
PLAUMP15
USER MANUAL
®
®

Auto Mug Press V2.0 Auto Mug Press V2.0
1
www.pydlife.com
www.pydlife.com
2
SAFETY INSTRUCTIONS
To avoid injury or death caused by electric shock, please
read all the instructions before using the machine.
1. Keep the machine unplugged when moving it;
2. Use the machine on a flat and stable table in a
ventilated room;
3. Wear heat-resistant gloves when using the machine;
4. Do not use the machine in a hazardous place;
5. Do not use the machine when it can’t function
properly;
6. Do not disassemble and reassemble the machine
without special guidance;
7. Do not plug the machine in unsuitable AC outlet;
8. Do not touch the mug heater when the machine is
heating up;
9. This machine is not intended for use by people
(including children) who lack of physical or sensory
capability, experience and knowledge, unless they
have been given supervision and guidance by a
person responsible for their safety;
10. Children should use the machine under the
supervision of adults responsible for their safety;
PRODUCT INTRODUCTION
ProductModel CE-AUMP15BL/CE-AUMP15WH
CompatibleMugSize 11oz-15oz
RatedPower 280W
RatedVoltage/Frequency 220V/50Hz
RatedVoltage/Frequency 110V/60Hz
Mug Heater Five Indicator Lights
Switch with
Indicator
Light
Movable WrapMug Weight
Sensor
Note:
The mug heater is a vulnerable part, not covered by the warranty.
Power Cord Inlet
Note: Please make sure the voltage is compatible.
Connect the power cord to the inlet, and plug the mug press into AC
socket.
SWITCH ON/OFF
1. Press the switch button once to turn on the mug press.
2. Long press the switch button for 3 seconds to turn it off.

Auto Mug Press V2.0 Auto Mug Press V2.0
3
www.pydlife.com
www.pydlife.com
4
1. Turn off the machine or let it remain in off state;
2. Long press the button for 6 seconds;
3. Release the button as the indicator light blinks in orange;
4. The five lights above indicate different temp. levels. Press the
button once to choose.
5. Wait for 5 seconds for the auto-save, and the machine exits the
setting mode.
6. The initial temp. setting is 190℃ .
1. Turn off the machine or let it remain in off state;
2. Long press the button for 10 seconds;
3. Release the button as the indicator light blinks in green;
4. The five lights above indicate different time lengths. Press the
button once to choose.
5. Wait for 5 seconds for the auto-save, and the machine exits the
setting mode.
6. The initial time. setting is 80 seconds.
60 8070 90 100
℃
℉
S
TEMP. SETTING COUNTDOWN SETTING HOW TO PRINT?
Orange：Heating Green：Reaching the
set temperature
1. As the indicator light turns green,
you can start printing your mug.
2. Put the mug into the mug heater.
Once the sensor feels the mug, the mug
heater start to close and wrap the mug
automatically.
1 2
Be careful! Avoid direct
touch on heat platen!
180
356
185
365
190
374
195
383
200
392

Auto Mug Press V2.0 Auto Mug Press V2.0
5
www.pydlife.com
www.pydlife.com
6
INDICATOR LIGHT STATE
If the first light is blinking in white, it indicates the machine is
still heating up. The whole process takes about 180 seconds
If all lights are on, it indicates the whole printing process is
finished. The mug heater will open automatically, and you
can take out the mug.
EMERGENCY STOP
You can press the button anytime to open the
mug heater in case of emergency.
RESET DISORDERED BLINKING
LIGHT
Press the button for 5 times continuously to stop the
machine. After 15 seconds, it will restart automatically.
PRINTING SETTING
Use sublimation printer
to print your design on
sublimation paper.
For 11oz Mug For 15oz Mug
Temp.
Time
Temp.
Time