QABA 431-045V80 User manual

ASSEMBLY INSTRUCTION
US C000000
431-045V80
BABY BEDSIDESLEEPER

BEFORE ASSEMBLING THIS PRODUCT, PLEASE READ AND UNDERTSAND
THESE INSTRUCTIONS. INCORRECT ASSEMBLY MAY CAUSE TO BE UNSAFE.
DO NOT USE THIS PRODUCT OF ANY PARTS ARE BROKEN, TORN/MISSING.
RETAIN FOR FUTURE REFERENCE- READ CAREFULLY
INSTRUCTION MANUAL
BABY BEDSIDESLEEPER

PART
LIST
Strap x 3
Wheel x 2
Left Right
Support rod x 1

PART
LIST
Support frame
Height control button
Cradle
Folding button
on the top
Hook
Folding button on the bottom
Wheel with brake

Support rod
1.Take the product out of the carton and put it in a place out of children access. Insert the
support rod with the bracket button to the holder as below picture shown.(Press the button
of the downside support rod, and the casing hole will be firmly installed after the sleeve is
inserted.) Fasten the strap around the bottom of the cloth to fix it on the rod.
2.Insert the wheels into the wheels seats(pay attention the direction of the buckle towards
the inside of the product ). Then pull out the foot wheels until the buttons pops up.
Wheels
01
02

03
1.Flip the bed body, pull up until folding buttons under both sides pops up.
2.Pull up the upper rail until folding buttons on top pop up.
3.Grab both sides and pull up upper rail to the highest position.
4.Hook the hook.
Hook

For the convenience of storage in bags and transportation, this product can
be folded and collected. We an make the steps as below:
Step 1: Unhook, press both sides of the height adjustment button to keep the
bed body to a minimum height;
Step 2:Press upper folding buttons on both sides
and fold up the upper rail;
Step3:Press the bottom button to lower the bed
slightly. Hold by one hand, the other hand on the
other side of the folding button to completely fold
the whole bed.
Please adjust the height of the bed when the baby is not using this product.
Gently lift the bed body, then press the height adjustment button on both sides.
and the bed body will release the button after about 2CM downward.
The body of the bed continues to slide down to the height of second position.
if you need to continue to lower the height, repeat the previous action to the
other position.
OPERATION
Height
adjustment

This product can b connected to the adult's bed.
WARNING:
For your child's safety, please read this step carefully.
The use of adult bed, ensure both adult bed and this product are comply with
following situations.
The mattress height of this product and the adult's bed must be adjusted to the
same level, then completely connected without gap.
The strap is fixed together. The side connecting adult bed must be straight.
Please check carefully to ensure normal use of adult bed not affected when the
product connected to it.
Please confirm that the sheets, blankets and other items on the adult bed are not
covered on this product.
Operation step:
CONNECTING
2.a.Push inward both buttons at the upper end of zippers at the same time,
hold this operation for a while.
b. meanwhile ,lift the supporting rod to open the sides.
3.Put the supporting rod out of basket.
2.b.Lift
2.a.Push
3.Put
the button
1.Pull the zippers at both end of mesh windows to the lowest position.
1.Unzip
01
02
03

4.Put the baby crib close to adult bed as shown in below photo, then fix the
two beds through fasten belt within the pocket under baby crib.
Please ensure the fasten belt in horizontal position after fixed, while positions like
the 2 pics with cross Mark are forbidden .
a. Adjust fasten belt length to the width of adult bed mattress;
b. Take the metal plate of fasten belt through bottom of adult bed mattress and
fix it on the other side of adult bed(opposite to baby crib);
c. Insert the fasten buckle into the socket under baby crib.
Baby crib
mattress Adult bed mattress
Adult bed body
Adult bed mattress
Adult bed body Adult bed mattress
Adult bed body
04
Fasten belt 4.a.
05
5.When baby crib is not necessary attached to adult bed for use, the
disassembling operation method is just opposite to item 5,please put the rolled
fasten belt to the mesh pocket under the baby crib.

Please do not use any accessories that are not included in the product.
Please make sure that all accessories of this product are not damaged during the
transportation before assembling. If any accessories are damaged. keep it away
from children and ensure proper use of the product.
Please keep this product away from any source of fire and heat, including heating
electrical appliances gas fire, and so on.
Please carefully check whether the product is completely fixed, and ensuring that
all fixtures are properly installed before using this product.
Please stop using the product is properly placed and firmly fixed with the adult's bed
when using it join to the adult's bed. The height range for the top adult bed mattress
to the ground should be 36-44CM.
Please make sure the connection belt is tightly connected. This product must be
connected with the mattress of the adult bed and make sure there is no gap
between them before putting baby in the product.
Please place the strap away from the child.
The distance between the mattress and the top part of the bed no less than 20CM,
and only one mattress can be used in this product.
Please make sure the new mattress matches this product if you need to buy a
separate mattress.
Use mattress with suitable thickness according to the internal mark within this
product.
Please do not place this product against the wall or other product and change the
position of the product.
It's not allowed for more than one child to use this product at the same time.
WARNING

RETAIN THESE INSTRUCIONS FOR FUTURE REFERENCE AND FUTURE USERS
PLEASE READ CAREFULLY AND FOLLOW THE FOLLOWING DIRECTIONS & WARNINGS
TO BE USED BY ONE(1) CHILD ONLY . MAXIMUM:(WEIGHT:10KGS)
SUITABLE FOR BABY FROM 0 TO 5 MONTHS OLD.
INFANT CAN SUFFOCATE: In gaps between mattress too small or too thick and product side . Never add a
mattress, pillow , comforter , or padding . Use only the mattress provided by manufacturer . Never use a
water mattress with this product .
Only installation by adult is allowed. Children are prohibited.
Never use the crib/cradle if any part is broken, torn or missing.
Never use the body of a cradle without its frame.
Concerning the size of the mattress when not sold with the crib/cradle.
Do not use when the child can sit or kneel or pull itself up.
Do not close the fire, please use it under adult’s supervision. NO jumping on the bed.
Disassembly and assembly of this product can only be completed by adults.
Please do not damage product during the process of disassembly and assembly.
If the product is damaged, please do not use it and keep the product away from the children.
When washing mattress cover and fabric lining, don’t use dissolved and corrosive articles.
When connected to adult bed, we must ensure the leg height of the two beds are in the
same level. Fix the support rod under the mattress of this product and adult bed mattress
throuhg a strap. Fixed them firmly, and ensure there is no gap between the product and
the adult bed.
The thickness of the mattress chosen shall be such that the internal vertical height (surface
of the top of the mattress to the upper edge of the bed sides) is at least 200 mm in the
hightest position of the bed base.
To be aware of the risk of open fires and other sources of strong heat, such as electric bar
fires, gas fires, etc. in the near vicinity of the crib/cradle.
When a child is able to sit, kneel or to pull itself up, the crib/cradle shall not be used
anymore for this child.
All assembly fitting should always be tightened properly and that care should be taken
that no screws are loose, because a child could trap parts of the body or clothing (e.g.,
strings, necklaces, ribbons for babies dummies, etc.), which would pose a risk of
strangulation.
The crib/cradle should be locked in the fixed position when a child is unsupervised in it.
Young children should not be allowed to play unsupervised in the vicinity of a crib/cradle.
The crib/cradle should be placed on a horizontal floor.
NEVER LEAVE CHILD UNATTENDED , ALWAYS KEEP
ATTENTION
If you experience any difficulty with assembly, missing parts or use, please DO NOT
return to the store. Stores are unable to properly assist you, do contact us for direct
WARNING CHILD IN VIEW , EVEN WHEN CHILD IS SLEEPING .
CARE
If you experience any difficulty with assembly, missing parts or use, please DO NOT
return to the store. Stores are unable to properly assist you, do contact us for direct