Qazqa 90495 User manual

INSTRUCTION MANUALINSTRUCTION MANUAL
IP44
220~240V
50Hz
E27 Max.60W
Mossa WL LUX BLack
90495
INTRODUCTION
The unit is an automatic on/off switch for lantern lamp. When the light fades
in the evening, the lamp will switch on after the set light intensity is reached.
The lamp will switch off in the morning.
WHERE TO FIT YOUR BULKHEAD LIGHT
Please pay your attentions to the following:
1. Not to shadow or dirty the transparent Lens of CDS sensor, let the sensor
to catch the change of the natural light
2. Not allow artificial light to active the CDS sensor as Lighting may blink ON
and OFF
INSTALLATION
Installation the bulkhead light, please referring to the mounting and wiring
figure:
1. Installation by a licensed electrician and according to IEC wiring Regulation.
2. Switch power off at the meter box and ensure that there is no power to
the lamp.
3．Ensure install the unit according to the indicator of symbol direction on
cover ( UP)
4. Remove the Lampshade by Screwdriver, see figure.
5. Unscrew the Screw (A) and remove the Transparent Plate.
6. Mark the mounting hole position onto the wall. Drill and plug the wall at
the marked positions. Screw the lamp body to wall with suitable Mounting
Screws (supplied)
7. Connecting the main power wires to the Terminal Block (see the relative
symbols—right figure), the Cable must pass through the Wiring Rubber
Gasket.

INSTRUCTION MANUALINSTRUCTION MANUAL
Mossa WL LUX BLack
90495
8. Insert the Max. 60Watt / 220-240V~ 50Hz incandescent Bulb into the
Lamp-holder (E27)
9. Re-screw Transparent Plate.
10. Re-fit the Lampshade by hand.
11. After finish the mounting, Power on the bulkhead light.
NOTES FOR ELECTRICIAN-- Installation by a licensed electrician
1) The Bulkhead Light should be wired to its own lamp switch. Do not
interconnect with other lights on the same switch.
2) Do not connect to Dimmer.
Important:
1) Never modify the unit, there are no any user serviceable parts inside.
2) Before touching the lamp or replacement of the bulb, please switch off
first and then let it cool.
3) Any replacement of bulb, please Switch power off.

INSTRUCTION MANUALINSTRUCTION MANUAL
Mossa WL LUX BLack
90495
Bulb
Mounting and Wiring to Treminal
Transparent
Plate
Screwdriver
N
L
Terminal Block
Lampshade
Mounting Scerws
(2PCS)
Screw (A)
UP
113 mm
266 mm
112 mm
TECHNICAL DETAILS:
Voltage: 220-240 V~ 50 Hz
Wattage: Max. 60 Watt for incandescent
LUX control level: about 20lux
Weatherproof: IP44
Class I protection
> Rubber Power Cord must be used for outdoor light, such as
H05RR-F 3G 0.5mm².