QM TCEOC9001 User manual

Outdoor EoC Master
User Manual
Digital Innovations
TCEOC9001

1
Outdoor Eoc Master User Manual
Thank you for choosing Coaxial Broadband product. It is our honor for you to become our
customer. This product is used to carry Ethernet data signal through coaxial cable. After
broadcast and television operator complete television and data fiber to the Premises (FTTB), this
product helps realize household coaxial cable data, television signal transmission. It is widely
used in broadband Internet access, IPTV, voice over IP and other service.
Please read this manual carefully before you install, use and maintain the product. If you have
any problem, please contact our customer service, we will provide remote technical support
service for you.
Product list：
⚫Device 1
⚫User Manual 1
Note: if you find the packing list of items and equipment does not match, please
contact the supplier in time.
前 言Preface

2
Outdoor Eoc Master User Manual
This EOC (coaxial Ethernet) adopts Homeplug AV technology, which has the features of high
speed, high receive sensitivity, high stability and so on. It is suitable for long distance
transmission, high rate and high stability requirements place. The device not only has the
advantages of single way EOC, but also can respond flexibly to variety of corridor applications
to realize the transformation of one-way ordinary television network (CATV) network to the
bidirectional network under the condition of not change existing TV network equipment and
wiring. Products of the main features are as follows:
Item
Description
Standard
HomePlug-AV P1901
Interface
1*10/100/1000Base-T Ethernet Port
1*Console management Port
1 * MGMT Port
RF Feature
RF interface: 4*( F type Metric interface, 2*TV input, 2/*TV+ Data out
Modulation Mode: OFDM 4096/1024/256/64/16QAM,QPSK,BPSK
MAC Protocol：CSMA/CA、TDMA
Working Frequency：7.5～67.5 MHz（Channel bandwidth：60 MHz）
Out-off-Band Rejection：≥50 dB
RF Interface Impedance：75Ω
RF Interface Reflection Loss：≥16dB（87 MHz～1000 MHz）
In-band flatness：±1dB（8MHz is less than ±0.5）
Insertion Loss：≤1.5（87～1000 MHz）
Output Level:120dBuv
Software
Function
Transmission Loss: 90 dB
Support 802.1Q VLAN
Support loop detection
Support QoS
Support Slave configuration
Support Slave access authentication
Bidirectional 128 bits AES encryption transmission packet
Support isolation based on Slave
Support isolation switch based on Slave
Support MAC address dynamic learning
Support black and white list
Support storm control
Support multi-cast IGMP Snooping function (v1/v2/ v3)
Product Introduction

3
Outdoor Eoc Master User Manual
Support in-band management
Support remote upgrade
Support Web、Telnet、Console and SNMP（V1 V2 V3）web management
Equipment
Performance
Max. number of concurrent Slave：64
Max on line slaves at the same time: 32
MAC layer throughput＞300 Mbps（1518 bytes packet）
Forwarding latency: <30 ms (512 bytes packet, 80% max. throughput)
Compatibility
feature
Compatible with INT64 slave
Compatible with other manufacturer’s INT64 slave
Compatible with manufacturer’s INT74 slave
Equipment
Performance
Operation Temperature: -25 ~ 60℃
Operation Humidity: 10% ~ 90%, Non-condensation
Storage Temperature：-30ºC ~ 70ºC
Storage Humidity: 5% ~ 90%, Non-condensation
Physical
Features
Reliability: Average trouble-free working hours（MTBF）≥40000 hour
Electromagnetic compatibility: GB9254-2008 Class B GB/T 17618-1998
Dimension：230x130x100mm
Protection: waterproof, lightning protection, dust prevention
Product characteristics: corridor, outdoor (die-casting aluminum shell)
IP protection level: IP67
Lightning protection level: 4, 4 kV lightning protection( power supply module,
RF interface)
Equipment grounding
Power
Supply
Local power supply:AC220V
Support coaxial-cable power supply:AC60V（Optional）
Over current capacity :10A
Power Consumption:≤5W

4
Outdoor Eoc Master User Manual
⚫
Coaxial broadband masters are installed in weak current box of corridor or outside; the working
environment is relatively poor. To ensure the stable long-term work, please follow the below
environmental requirements to install the equipment:
1．Keep away from heat, keep ventilated;
2．Place the device on a flat surface;
3．Keep away from dust, keep dry.
To ensure normal work, please use the device according to instructions！
Installation Instructions

5
Outdoor Eoc Master User Manual
1 Equipment connection diagram
Above is the typical application of the product, please construct according to the picture above.
TV signal from optical receiver (TV In) combine with the modulated data signal (TV+EOC Out),
then sent to the corridor coaxial cable network. Data port is used to connect to operators’ data
network. Debug port (Console) is used to configure product parameters, configuration method
please check software configuration manual. Power is supplied by AC110V or AC60V adapter.
Installation
Operator’s
optical
receiver
Coaxial
network
Operator’s
Data Network
(入户线)
TV
TV+EOC
DATA
PWR

6
Outdoor Eoc Master User Manual
2Wiring instructions
Port
Port type
Function
TV Signal *2
Imperial -5F
TV Signal input port. Used to connect to corridor optical receiver
Composite signal *2
Imperial -5F
Signal output port, output TV/Data composite signal
User to connect to coaxial cable network
Data signal
RJ45
10M/100M/1000M Ethernet port, Used to uplink operator network。
(MGMT management port；ETH data port)
Console
RJ45
Debug port，Command line Port, baud rate 115200。
Power
AC/Imperial -5F
AC110V/AC60V

7
Outdoor Eoc Master User Manual
Warranty Card
Product model
MAC
Purchase date
Remark
Customer name
Address
Telephone
Mobile phone
Warranty Service Terms:
I. In case of quality problems with the product within 15 days from the date of sale, the users
are entitled to return the product unconditionally. (The product and external package should be
free of damage or stain).
II. The warranty period of the product is one year. For the quality problems occurred in the
warranty period, we provide free repair services. After the quality warranty period, we will
charge for the accessories appropriately.
III. In case of damages caused by improper use, accidental damage or disassembly, or alteration
to the warranty card, the warranty does not apply.
IV. The user is required to well keep the warranty card. In case of loss, we do not re-issue
another one.
V. The warranty card is valid with the seal of the distributor.
Seal
Valid after completing and
sealing