www.avsl.com 160.491UK Manual
In the box:
Please check the contents to ensure that the product has been received in good condition.
•MoonCloud-400 Fog Machine
•Wired control unit
•RF wireless remote
•UK/EU Mains Leads
•User guide
If you find any accessory is missing or the machine has arrived with damage, please contact your local
dealer at once. Do not try to fix this item yourself or you will invalidate the warranty. Please keep the
original packaging and invoice for any possible replacement or return demands.
Warnings:
1. To prevent risk of fire or electric shock, do not expose electrical parts to water or moisture.
2. If liquids are spilled on areas other than inside the fluid tanks, disconnect the mains, allow the
unit to dry out and have it checked by qualified personnel before use.
3. Avoid any impact, dropping or extreme pressure to the housing.
4. No user serviceable parts inside - do not open the case.
5. Allow the unit to acclimatise to room temperature before operating.
6. The MoonCloud-400 has a built-in fluid container so should be operated in an upright position.
7. Ensure that the unit is positioned on a stable, non-slip surface.
Safety and Cleaning:
1. Check for correct mains voltage and condition of IEC lead before connecting to mains.
2. This unit must be earthed.
3. This unit uses a heating element –be aware that parts of the housing may be hot during use!
4. Use a soft dry or slightly damp cloth to clean the casing.
5. Do not use strong solvents for cleaning the housing.
6. Clean the fog mechanism periodically by operating with distilled water.
7. It is also recommended to use fog machine cleaning fluid (160.670UK) periodically.
Recommended Fluids:
For the MoonCloud-400 fog machine, we strongly recommend the following fluids which have been
specifically formulated to perform best with heater-based fog machines:
Setting Up:
1. Unpack the MoonCloud-400 unit.
2. Unscrew the top cap of the tank and remove to fill with fog fluid.
3. Replace the bottle and screw the cap securely, making sure that the pipe is fed down to the
bottom of the bottle to ensure a consistent flow of fluid.
4. Connect the wired control unit to the socket marked “Remote Control”on the rear panel.
5. Connect the IEC mains plug and power the unit on.
6. The unit will begin the warming up process which normally takes around 3-5 minutes.
